Шуруповерты FLEX PD 2G 18/2.5 Set 436585 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
PD 2G / DD 2G / ID 1/4"
24
Insert the battery fully into the charger
until it clicks into place.
– The time remaining in the charging
process (until the battery is fully
charged) and a graphic representation
of the state of charge are shown
alternately in the display.
– The display backlighting lights up
orange when the battery is charged
less than 80%.
– When the battery charge reaches 80%
the display lights up green and OK is
indicated.
The battery is fully charged when the
display
appears.
The green backlighting goes out after
a short time.
Remove the battery from the charger.
Pull out the mains plug.
NOTE
If the display flashes after the battery is
inserted in the charger, there is a fault in the
battery or in the charger.
Display flashes slowly.
Backlighting orange.
The battery is too hot or too cold. The
charging process starts when the battery
reaches the charging temperature
(0°C...55°C).
Display flashes rapidly.
Backlighting red.
Remove the battery from the charger and
insert again. If the same display persists,
the battery is faulty. Replace the battery or
have it checked at an authorised repair
shop.
If this error message is displayed again with
a different battery, this indicates that there is
a fault in the charger. Have the charger
checked at an authorised repair shop.
Maintenance and care
Cleaning
WARNING!
If metals are worked over a prolonged
period, electroconductive dust may become
deposited inside the housing.
Clean the power tool and ventilation slots at
regular intervals. Frequency of cleaning is
dependent on the material machined and
the duration of use.
Regularly blow out the housing interior
and motor with dry compressed air. Keep
the power tool running while doing this.
Charger
WARNING!
Before performing any work, pull out
the mains plug. Do not use water or liquid
detergents.
Remove dirt and dust from the housing
with a brush or a dry cloth.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
For other accessories, in particular cutting
accessories, please refer to the
manufacturer’s catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
Transport
The lithium equivalent content of the batteries
contained in the scope of delivery is below the
relevant limit values. Therefore the battery as
a separate component and the power tool with
its scope of delivery are not subject to national
or international dangerous goods regulations.
