FLEX PD 2G 18/2.5 Set 436585 - Инструкция по эксплуатации - Страница 23

PD 2G / DD 2G / ID 1/4"

23

3. Set torque preselection to the required 

setting.

4. Set speed to the required setting.

5. Set the required direction of rotation.

6. Hold the power tool with one hand on 

the handle and assume the working 

position.

7. Switch on the power tool.
At the end of work:

8. Release the trigger switch.

9. Move the direction preselector switch 

(2) to the middle position.

Charger

1

Insertion slot for battery

2

Contacts

3

Ventilation slots

4

Operating state display

5

Power cord with mains plug

The CA 10.8/18.0 charger is designed to 

charge FLEX batteries of the following types

– AP 10.8 (2.5 Ah),

– AP 18.0 (2.5 Ah),

– AP 10.8 (5.0 Ah) and 

– AP 18.0 (5.0 Ah).

Tips for a long battery service life

CAUTION!

–

Never charge batteries at temperatures 

below 0 °C or above 55 °C.

–

Do not charge batteries in environments 

with high air humidity or ambient 

temperature.

–

Do not cover batteries and the charger 

during the charging process.

–

Pull out the charger mains plug at the 

end of the charging process.

Battery and charger heat up during the 

charging process. This is perfectly normal!
Lithium-ion batteries do not exhibit the 

established “memory effect”. Nevertheless, 

a battery should be completely discharged 

before charging and the charging process 

should always be fully completed.
If batteries are not used for an extended 

period of time, store them partially charged 

in a cool place.
Charging process

CAUTION!

Insert only original batteries in the supplied 

charger.



Insert the charger mains plug.

The display backlighting lights up green 

for 2 seconds and then goes out again. 

OK is displayed.