Шуруповерты FLEX PD 2G 18/2.5 Set 436585 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
PD 2G / DD 2G / ID 1/4"
22
Move the selector switch to the required
stage:
1: Low speed, high torque
2: High speed, low torque
Inserting the tools
CAUTION!
Before carrying out any work on the
power tool, move the direction preselector
switch (2) to the middle position.
Chuck (PD 2G 18.0/DD 2G 18.0)
Drill bits with a diameter of 1.5–13 mm,
¼" screwdriver bits and ¼" bit holders are
securely held in the chuck.
Grip the power tool firmly with one hand
and turn the chuck with the other hand.
– Turn counterclockwise to open the chuck
further.
– Turn clockwise to close the chuck.
Insert the tool.
Close the chuck fully.
Move the direction preselector switch to
the required position (left/right).
Carry out a test run to check that the tool
is chucked in the centre.
Tool holder (ID 1/4" 18.0)
NOTE
¼" screwdriver bits and bit holders are
securely held in the tool holder.
Pull the tool arrester forwards and press
the tool in as far as it will go.
Release the tool arrester.
Pull the tool arrester back to remove the
tools.
Switching on the power tool
To switch the power tool on:
Press the trigger switch.
The power tool trigger switch allows the
operator to increase the speed in
increments up to the maximum speed.
To switch the power tool off:
Release the trigger switch.
NOTE
–
The power tool is equipped with a brake
which stops the cutting accessory as
soon as the trigger switch is released.
–
When using the power tool continuously,
the operator should work primarily with
the trigger switch fully depressed.
Working with the power tool
CAUTION!
Before carrying out any work on the
power tool, move the direction preselector
switch (2) to the middle position.
1. Insert the battery.
2. Insert the tool.
