Dreame D10S Pro - Инструкция по эксплуатации - Страница 15

24

25

EN

EN

Specifications

Auto-Empty Base

Under normal use of condition, this equipment should be kept a 

separation distance of at least 20 cm between the antenna and 

the body of the user.

Robot

Model

RLS6AD

Charging Time

Approx. 6 hours

Rated Voltage

14.4 V

Rated Power

46 W

Operation 

Frequency

2400-2483.5 MHz

Maximum 

Output Power

＜ 20 dBm

Battery Disposal and Removal

The built-in lithium-ion battery contains substances that are 

hazardous to the environment. Before disposing of the battery, 

make sure the battery is removed by qualified technicians and 

discarded at an appropriate recycling facility.  
• the battery must be removed from the appliance before it is 

scrapped;   

• the appliance must be disconnected from the supply mains when 

removing the battery;   

• the battery is to be disposed of safely.  

CAUTION:
• Before removing the battery, disconnect the power and run out 

the battery as much as possible.   

• Unneeded batteries should be discarded at an appropriate 

recycling facility.   

• Do not expose to high temperature environment to avoid risks of 

explosion.   

• Under abusive conditions, liquid may be ejected from the battery. 

If contact occurs, flush with water and seek medical help.

WEEE Information

All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with 

unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated 

collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and 

recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for 

more information about the location as well as terms and conditions of such collection points.

Removal Guide

1. Turn over the robot, use a proper tool to remove the screws on 

the back of the robot, and then remove the cover.
2. Unplug the terminals between the battery and PCB board to 

remove the battery.  

Model

RCS2

Rated Input

220-240 V     50-60 Hz

Rated Output

19.8 V   1 A

Rated Power

800 W