Dreame D10S Plus - Инструкция по эксплуатации - Страница 10

14

15

EN

EN

Routine Maintenance

Parts

To keep the robot in good condition, it is recommended to refer to the 

following table for routine maintenance.

Part

Maintenance 

Frequency

Replacement Period

Mop pad

After each use

Every 3 to 6 months

Main brush

Once every 2 weeks

Every 6 to 12 months

Dust bin filter

Every 3 to 6 months

Side brush

Auto-empty base's 

signaling area

Once every month

/

Charging contacts

Auto-empty vent

Universal wheel

Laser Distance

Sensor (LDS)

AI visual sensor

Cliff sensors

Water tank

Clean it as needed

/

Dust bin 

Dust collection bag

/

8-10 weeks

Note:

 The replacement frequency will depend on your usage of the robot. If an exception 

occurs due to special circumstances, the parts should be replaced.

Clean the Dust Bin and Filter

1. Open the robot cover and press the bin clip to remove the dust bin.

2. Open the bin cover and empty the bin as shown in the diagram.

3. Clean the auto-empty vent.

Routine Maintenance

4. Remove the filter and tap its basket gently.

5. Rinse the dust bin and filter with water and dry them completely 

before reinstalling.

Note: 

Do not attempt to clean the filter with a brush, finger, or any sharp objects so as to 

avoid damaging it.

·

Rinse the dust bin and filter with clean water only. Do not use any detergent.

·

Use the dust bin and filter only when they are completely dry.

Note:

Clean the Mopping Module

1. Slide the two release clips on the side of water tank to remove 

the mopping module, and then pull the mop pad off the mopping 

module.

2. Pour out the water in the tank. Clean with water only and leave 

to air dry before re-installing.

Note: 

Do not directly expose the water tank to sunlight.

12

6

1

11

5

7

2

10

4

8

3

9

24 hrs