Bosch GOP 18 V-EC - Инструкция по эксплуатации - Страница 17

 English | 

17

Bosch Power Tools

1 609 92A 117 | (7.4.15)

Mounting/Replacing the Application Tool/Accessory

If required, remove an already mounted application tool/ac-
cessory.

For this, open the SDS lever 

8

 to the stop (not further) and re-

move the application tool.

Mount the requested application tool/accessory (e. g. plunge 
cut saw blade 

11

) in such a manner on the tool holder 

9

 that 

the offset faces downward (see illustration on the graphics 
page; marking on the application tool/accessory is readable 
from above).

Turn the application tool/accessory to a position favourable 
for the respective job, and allow it to engage into the cams of 
the tool holder 

9

. 12 different positions are possible, each 

offset by 30 °.

Close SDS lever 

8

 so that it faces against the housing of the 

power tool.



Check the tight seating of the application tool/accesso-
ry. 

Incorrect or not securely fastened application tools/ 

accessories can come loose during operation and pose a 
hazard.

Mounting/Replacing a Sanding Sheet on the Sanding 
Plate

The sanding plate 

12

 is fitted with Velcro backing for quick 

and easy fastening of sanding sheets with Velcro adhesion.

Before attaching the sanding sheet 

13

, free the Velcro back-

ing of the sanding plate 

12

 from any debris by tapping against 

it in order to enable optimum adhesion.

Position the sanding sheet 

13

 flush alongside one edge of the 

sanding plate 

12

, then lay the sanding sheet onto the sanding 

plate and press firmly.

To ensure optimum dust extraction, pay attention that the 
punched holes in the sanding sheet match with the holes in 
the sanding plate.

To remove the sanding sheet 

13

, grasp it at one of the tips and 

pull it off from the sanding plate 

12

.

You can use all sanding sheets, fleece pads/polishing cloth 
pads of the Delta 93 mm series of Bosch accessory program.

Sanding accessories, such as fleece pads/polishing cloth 
pads, are attached to the sanding plate in the same manner.

Selecting the Sanding Sheet

Depending on the material to be worked and the required rate of material removal, different sanding sheets are available:

Scraper, flexible * Silicone and other 

elastic materials

Base plate for 
sanding, series 
Delta 93 mm*

Depends on sanding 
sheet 

Accessory

Material

* Optional accessory; for the complete accessories please see Bosch ac-
cessory programme.

Sanding disc Material

Application

Grain size

– All wooden materials 

(e. g., hardwood, soft-
wood, chipboard, build-
ing board)

– Metal materials

For coarse-sanding, e. g. of rough, unplaned beams and 
boards

coarse

40
60

For face sanding and planing small irregularities

medium

80

100
120

For finish and fine sanding of wood

fine

180
240
320
400

– Paint
– Varnish
– Filling compound
– Filler

For sanding off paint

coarse

40
60

For sanding primer (e. g., for removing brush dashes, 
drops of paint and paint run)

medium

80

100
120

For final sanding of primers before coating

fine

180
240
320
400

OBJ_BUCH-1808-002.book  Page 17  Tuesday, April 7, 2015  4:33 PM