Philips FC8710 - Инструкция по эксплуатации - Страница 8

Before first use

Mounting the side brushes

 1 

 Unpack the side brushes and place the robot upside down on a table or on the floor.

 2 

 Push the side brushes onto the shafts on the bottom of the robot (Fig. 11).

Note: Make sure you attach the side brushes properly. Press them onto the shaft until you hear them 

lock into position with a click.

Removing the protection tag from the remote control

The remote control (FC8710) works on a CR2025 coin-shaped batter y. This batter y is protected 

with a protection tag that has to be removed before use.

 1 

 Pull the battery protection tag out of the battery compartment of the remote control (Fig. 12).

,

Now the remote control is ready for use.

Preparing for use

Installing the docking station

 1 

 Insert the small plug of the adapter into the socket on the docking station (1) and insert  

the adapter into the wall socket (2). The display of the docking station lights up (Fig. 13).

 2 

 Place the docking station on a horizontal, level floor against the wall (Fig. 14).

Note: Make sure that there are no obstacles or height differences 80cm in front, 30 cm to the right  

and 100cm to the left of the docking station.

Charging

When charging for the first time and when the rechargeable batter y of the robot is empty,  

the charging time is four hours. 

Your robot can be charged in two ways:

 - On the docking station, either manually or automatically during use;

 - By connecting the robot directly to the mains

Note: When the rechargeable battery is fully charged, your robot can clean for up to 100 minutes.

Charging on the docking station 

 1 

 Place the robot on the plugged-in docking station (Fig. 15).

 2 

 Press the power switch to switch on the robot (Fig. 16).

 3 

 The on/off indicator on the display starts flashing (Fig. 17).

 4 

 When the rechargeable battery is fully charged, the on/off indicator on the display stops 

flashing (Fig. 18).
Charging automatically during use

 1 

 When the robot has finished cleaning or when only 15% of the battery power remains,  

it automatically returns to the docking station to recharge. When the robot returns to  

the docking station, the on/off indicator flashes quickly (Fig. 19).

 2 

 When the rechargeable battery is fully charged, the battery indicator on the display of the 

robot stops flashing.

Note: The robot only returns to the docking station automatically when it started cleaning from  

the docking station.

ENGLISH

8