Einhell TC-TS 315 - Инструкция по эксплуатации - Страница 36

GB

- 36 -

•

 Always push the cross stop or accessory 

slide forward until the workpiece is cut all the 

way through.

•

 Switch off the saw again. Do not remove the 

offcut until the blade has stopped rotating.

9. Cleaning, maintenance and

ordering of spare parts

Danger!

Always pull out the mains power plug before star-

ting any cleaning work.

9.1 Cleaning

•

 Keep all safety devices, air vents and the 

motor housing free of dirt and dust as far as 

possible. Wipe the equipment with a clean 

cloth or blow it with compressed air at low 

pressure.

•

 We recommend that you clean the device

immediately each time you have finished 

using it.

•

 Clean the equipment regularly with a moist 

cloth and some soft soap. Do not use 

cleaning agents  or solvents; these could at-

tack the plastic parts of the equipment. Ensu-

re that no water can seep into the device. The 

ingress of water into an electric tool increases 

the risk of an electric shock.

9.2 Maintenance

There are no parts inside the equipment which  

require additional maintenance.

9.3  Ordering spare parts and accessories

Please provide the following information when 

ordering spare parts:

•

Type of unit

•

Article number of the unit

•

ID number of the unit

•

Spare part number of the required spare part

For our latest prices and information please go to 

www.isc-gmbh.info

Tip! For good results we 

recommend high-quality ac-

cessories from 

! 

www.kwb.eu 

welcome@kwb.eu

9.4 Transport

Only ever transport the machine by lifting it by the

saw table. Never use the safety devices such as

the saw blade guard and stop rails for handling or

transporting purposes.

To transport with the slide (special accessory) 

fi

 tted, the locking screw (117) must be secured so 

that it stays in one position and cannot slip.

9.5  Additional notes on maintenance

Check the following each time before using

•

that the On/Off switch can be reliably swit-

ched off.

•

the braking time after switching off (<10 se-

conds)

If the On/O

ff

  switch is defective or the braking 

time exceeds 10 seconds, do not use the machi-

ne any more and contact the customer services 

team.

Always ensure that you place the machine on a 

fi

 rm surface during transport, assembly, disas-

sembly, disabling and scrapping, to make sure 

that it cannot topple over, fall over or move in an 

uncontrolled manner.

10. Disposal and recycling

The equipment is supplied in packaging to pre-

vent it from being damaged in transit. The raw 

materials in this packaging can be reused or 

recycled. The equipment and its accessories are 

made of various types of material, such as metal 

and plastic. Never place defective equipment in 

your household refuse. The equipment should 

be taken to a suitable collection center for proper 

disposal. If you do not know the whereabouts of 

such a collection point, you should ask in your 

local council o

ffi

  ces. 

11. Storage

Store the equipment and accessories in a dark 

and dry place at above freezing temperature. 

The ideal storage temperature is between 5 and 

30 °C. Store the electric tool in its original pa-

ckaging.

Anl_TC_TS_315_U_SPK9-1.indb   36

Anl_TC_TS_315_U_SPK9-1.indb   36

23.03.2020   09:16:58

23.03.2020   09:16:58