Makita DHS680Z - Инструкция по эксплуатации - Страница 7

7 

21. 

Always observe that the lower guard is 
covering the blade before placing saw down on 
bench or floor.

 An unprotected, coasting blade will 

cause the saw to walk backwards, cutting whatever 
is in its path. Be aware of the time it takes for the 
blade to stop after switch is released. 

22. 

To check lower guard, open lower guard by 
hand, then release and watch guard closure. 
Also check to see that retracting handle does 
not touch tool housing.

 Leaving blade exposed 

is VERY DANGEROUS and can lead to serious 
personal injury. 

Additional safety warnings 

23. 

Use extra caution when cutting damp wood, 
pressure treated lumber, or wood containing 
knots.

 Maintain smooth advancement of tool 

without decrease in blade speed to avoid 
overheating the blade tips. 

24. 

Do not attempt to remove cut material when 
blade is moving. Wait until blade stops before 
grasping cut material.

Blades coast after turn off. 

25. 

Avoid Cutting Nails. Inspect for and remove 
all nails from lumber before cutting. 

26. 

Place the wider portion of the saw base on that 
part of the workpiece which is solidly 
supported, not on the section that will fall off 
when the cut is made. As examples, Fig. 1 
illustrates the RIGHT way to cut off the end of a 
board, and Fig. 2 the WRONG way. If the 
workpiece is short or small, clamp it down. DO 
NOT TRY TO HOLD SHORT PIECES BY HAND! 

Fig. 1

014997 

Fi

g

. 2

000190 

27. 

Before setting the tool down after completing 
a cut, be sure that the lower guard has closed 
and the blade has come to a complete stop. 

28. 

Never attempt to saw with the circular saw 
held upside down in a vise. This is extremely 
dangerous and can lead to serious accidents. 

000029 

29. 

Some material contains chemicals which may be 
toxic. Take caution to prevent dust inhalation and 
skin contact. Follow material supplier safety data. 

30. 

Do not stop the blades by lateral pressure on 
the saw blade. 

31. 

Do not use any abrasive wheels. 

32. 

Only use the saw blade with the diameter that is 
marked on the tool or specified in the manual.

Use of an incorrectly sized blade may affect the 
proper guarding of the blade or guard operation 
which could result in serious personal injury. 

33. 

Keep blade sharp and clean.

 Gum and wood pitch 

hardened on blades slows saw and increases potential 
for kickback. Keep blade clean by first removing it from 
tool, then cleaning it with gum and pitch remover, hot 
water or kerosene. Never use gasoline. 

34. 

Wear a dust mask and hearing protection 
when use the tool. 

SAVE THESE INSTRUCTIONS. 

WARNING: 

DO NOT let comfort or familiarity with product (gained 
from repeated use) replace strict adherence to safety 
rules for the subject product. MISUSE or failure to 
follow the safety rules stated in this instruction 
manual may cause serious personal injury. 

ENC007-10 

IMPORTANT SAFETY 
INSTRUCTIONS 
FOR BATTERY CARTRIDGE 

1. 

Before using battery cartridge, read all 
instructions and cautionary markings on (1) 
battery charger, (2) battery, and (3) product 
using battery. 

2. 

Do not disassemble battery cartridge.