Timberk TGH 4200 X2 - Инструкция по эксплуатации - Страница 7

www.timberk.com • gas heater

7

1. Regularly check the integrity of the gas hose between the gas pressure 

reducer and gas valve of the appliance. If any damage of the hose is found, 

operation of the appliance is prohibited and the hose should be replaced.
2. Regularly check all gas joints, pipes, and devices for gas leaks (using 

soapy water). If any gas leak is found, immediately switch the heater off, 

disconnect the gas cylinder, and contact the dealer or manufacturer’s 

service center.
3. The appliance should be regularly washed to remove dust and dirt from 

outer surfaces, since they affect efficiency of its operation and temperature 

parameters of room heating. Before commencing preventive maintenance, 

switch the appliance off and let the appliance cool down and then wipe its 

surface with slightly wet soft rag.
4. Detergents including those containing abrasives in composition are not 

recommended for washing. Exclude damage of the appliance with sharp 

objects, since scratches on the painted surface may result in rusting.
5. The rear surface of the gas-fired heater also should be periodically 

cleaned to remove dust and dirt. The procedure of preventive cleaning 

should be carried out periodically to maintain the technical condition of the 

heater and keep its appearance for long years.

8. MAINTENANCE

10. TRANSPORTATIOM AND STORAGE

Temperature 

requirements*
Humidity 

requirements*

We are exploring new technologies and we constantly improving the quality 

of our products. That’s why specifications, design and accessories are 

subject to change without any specific notice.

Transportation and 

storage

From -30 °С to 

+50 °С
From 15% to 85% 

(without a condensate)

Upon completion of the service life, the heater should be disposed 

according to the effective local regulations, rules, and methods. For more 

details on disposal of the gas-fired heater, please contact a representative 

of the local authority.

If you are not able to remedy a malfunction according to the recommen-

dations or other malfunctions occur, contact the authorized service center 

of Timberk.

11. DISPOSAL

9. TROUBLESHOOTING

Troubleshooting

Probable cause

Remedy

Pilot light is lit evenly, but 
goes out when you release 
the gas control knob

Thermocouple wire is disconnected 
from the gas valve

Connect the thermocouple to the gas valve

Incorrect position sensor 
thermocouple relative to the pilot 
burner

Adjust the position of the thermocouple 
sensor in relation to the pilot burner so that 
he was on fire

Pilot burner burns unevenly, 
flame detached from the 
base and goes off when you 
release the gas control knob

Low gas quality is used

Use a good quality gas

Faulty gearbox - too high or low gas 
pressure

Contact an authorized service center Timberk

Strong ceramic burner flame

Faulty gearbox - too high gas pressure

Contact an authorized service center Timberk