Timberk TGH 4200 X2 - Инструкция по эксплуатации - Страница 6

www.timberk.com • gas heater

6

Device control

Connecting the gas heater
1. Check for proper assembly and installation of the gas heater, and the 

accession gas tank instructions below

2. Gently remove the valve gas cylinder and check for gas leaks with 

soapy water. The formation of bubbles indicates the presence of a gas 

leak in the wiring. In this case, replace the valve of the gas container, 

immediately contact an authorized service center Timberk to fix this 

problem

3. Turn the gas valve of heater counterclockwise until it stops at maximum 

power and push it in. (fig.2)

4. Fast light radiating heater on the obverse ceramic panel with the ignition 

matches or lighters (Attention! there is a risk of fire, be extremely careful.
Hold the gas valve in the clamped position for 10 seconds. If the burner 

goes out, wait 5-10 minutes and repeat the above steps again.

5. To adjust the power level, heating and/or installation minimum power 

turn the gas valve to the heater clockwise.

Gas valve of heater

Turn-off gas heater

1. Tighten the gas valve on a gas cylinder to another. Thus the supply of 

gas to the gas heater must cease.

2. Turn the gas valve to the heater clockwise until it stops.
3. Ensure that no flame before the ceramic panel heater.

1. Make sure that the heater is switched off.
2. If it is necessary to replace an empty gas cylinder, shut gas screwing the 

gas check valve on the cylinder clockwise up to the stop.

3. Remove the cylinder clamp and take the cylinder out of the heater body.
4. Remove the gas pressure reducer from the cylinder unscrewing its cap 

nut.

5. Connect and install a full gas cylinder as indicated in Section 
6. Preparation for work.

IMPORTANT! 

Never disconnect the gas regulator (reducer) from a gas 

bottle at the time of the heater. Before disconnecting 

always check no flame on a gas burner.

IMPORTANT! 

For some time after turning off the device remains hot. 

Do not touch the appliance with bare hands, cover the 

device, move or lift it.

IMPORTANT! 

Do not smoke during replacement of the cylinder.
Do not replace the cylinder, if there is an open flame 

source nearby.
Keep gas cylinders in a separate well-ventilated room 

far from combustible materials. It is prohibited to store 

and operate gas cylinders in flats of high-rise buildings, 

cellars, garrets.

Fig. 2

Increase

power                      

 Decrease

power