Timberk TGH 4200 X2 - Инструкция по эксплуатации - Страница 4

www.timberk.com • gas heater

4

1. Carefully remove the heater from the package.
2. Carefully install the enclosed gas hose not twisting or breaking it. For 

that, screw one end of the hose onto the gas valve connector, while the 

other end onto the connector of the enclosed gas pressure controller 

(reducer). Secure the hose ends on the connectors with jubilee clips.

3. Install a paronite/rubber spacer inside the cap nut checking its integrity 

beforehand and then carefully screw the nut on the outlet of an already 

prepared gas cylinder having appropriate capacity (a gas cylinder is not 

included in the delivery set and purchased separately). Twisting of the 

hose is strongly not allowed.

4. Slowly turning the gas pressure controller (cylinder check valve), make 

1. Heater on base - 1 pc.
2. Mounting set - 1 pc.
3. Instruction manual and warranty card - 1

1. Heater body
2. Ceramic gas-fired burner
3. Protective face grille

Fig. 1

NOTE:

To improve products quality, design and technical 

characteristics of the convector, as well as its scope 

of delivery can be revised without advance notice.

4. GAS-FIRED HEATER DESCRIPTION

6. PREPARATION FOR WORK

5. DELIVERY SET

Parameter

unit

TGH 4200 X0

TGH 4200 X2

Gas pressure

mbar

29-30

29-30

Heating room area

m

3

20-45

20-45

Dimensions

mm

335x155x405

325х320х345

Weight

Kg

2,6

1,96

IMPORTANT! 

To improve the product quality, the design and technical 

specifications of the heater, as well as its delivery set 

can be modified by the manufacturer without preliminary 

notification.

sure that no gas leaks are present. For that:

• 

Lubricate all joints with soapy water. Gas leaks cause formation of 

bubbles in permeable places.

• 

NEVER USE MATCHES OR LIGHTERS for gas leak checks.

If you find a gas leak, shut gas and contact your dealer or manufacturer’s 

service center.

5. Carry the heater to the supposed place of operation observing the rules 

and precautions described in Section 2 of this Instruction Manual.

6. The appliance is ready for work.

1

1

2

2

3

3

TGH 4200 X0

TGH 4200 X2