Lavor Pro TUCSON 2017 LP 8.671.0004 - Инструкция по эксплуатации - Страница 22

effective from the date of purchase. 

The following are not included in the warran-

ty:

 - Parts subject to normal wear. - Rubber parts, 

charcoal, filters and the accessories and optional 

accessories. - Accidental damage, caused by trans-

port, neglect or inadequate treatment, incorrect or 

improper use and installation failing - The warranty 

shall not cover any cleaning operations to which 

the operative components may be subjected, such 

as clogged nozzles and filter blocked due to lime-

stones. 

>  DISPOSAL

As the owner of electrical or electronic 

equipment, the law (in accordance with the EU 

Directive 2012/19/EU on waste from electrical and 

electronic equipment and the national laws of the 

EU Member States that have implemented this Directive) 

prohibits you from disposing of this product or its electri-

cal / electronic accessories as municipal solid waste and 

obliges you to make use of the appropriate waste collec-

tion facilities. The product can be disposed of by returning 

it to the distributor when a new product is purchased. The 

new product must be equivalent to that being disposed of.

Disposing of the product in the environment can cause 

great harm to the environment itself and human health.

The symbol in the figure indicates the urban waste con-

tainers and it is strictly prohibited to dispose of the 

equipment in these containers. Non-compliance with the 

regulations stipulated in the Directive 2012/19/EU and the 

decrees implemented in the various EU Member States is 

administratively punishable.

>     REPAIRS - SPARE PARTS

For any problems not mentioned in this manual, 

or if the machine breaks down, you are urged 

to contact an 

Authorized After-Sales Service

for the relative repair or for any replacement of 

components with original spare parts. Use ex-

clusively original replacement parts. 

>     TROUBLESHOOTING

Before doing any work on the machine, disconnect 

the electricity and water supplies and discharge the 

pressure. Proceed systematically to identify faults 

following the chart below; if you are still unable to 

eliminate the problem, call in the 

Authorized After-

Sales Service

.

Fault

When switch “ON” the 

machine will not start wor-

king

Cause 

-  Plug not properly inserted in 

socket.

-  Electric socket is faulty.

-  The main voltage is insuf-

ficient.

-  The pump is stuck.

-  Gauge of extension lead not 

sufficient.

Repair 

-   Fit plug in power socket 

correctly.

-  Have electrical socket 

checked.

-  Have a check made on the 

suitability of the mains 

system.

-  Turn switch to ON while 

keeping nozzle trigger 

pressed; if problem persists, 

contact an authorised ser-

vice centre.

-  Refer to maintenance sec-

tion.

Fault

The motor stops suddenly

Cause 

-  Thermic safety switch has 

tripped due to the overheat-

ing.

-  Cable extension seems to 

be inadequate.

Repair 

-  Leave motor to cool for a 

few minutes. If the problem 

persists, contact an 

authorised service centre.

- 

Refer to maintenance 

section.

Fault

The pump doesn’t reach 

the necessary pressure

Cause 

-  Insufficient flow.

-  Water inlet filter is clogged.

-   Suction/delivery valves are 

clogged or worn out.

-  

Pressure regulator valve 

set on minimum.

-   The nozzle is worn out.

EN

22