Bosch UniversalAquatak 125 0.600.8A7.A00 - Инструкция по эксплуатации - Страница 12

12

 | English 

F 016 L81 568 | (26.4.17)

Bosch Power Tools

Connecting to the mains



The voltage indicated on the rating 

plate must correspond to the voltage 
of the power source.



We recommend that this equipment 

is only connected into a socket which 
is protected by a circuit-breaker that 
would be actuated by a 30 mA residu-
al current.



Remove the plug from socket when-

ever the machine is left unattended 
for any period.



The electric supply installation 

should comply with IEC 60364-1.



If the supply cord is damaged, it must 

be replaced by the manufacturer, its 
service agent or similarly qualified 
persons in order to avoid a hazard.



If the plug is damaged, pay attention 

to the following:



Plugs and sockets situated near the 

work site or outdoors should be to 
class IP 55 of BS 5490 to provide ad-
equate protection against ingress of 
water, etc. and cable entries require 
effective sealing. Rubber shrouds 
should be provided over cable 
glands. Drip-proof (class IP X2 of 
BS 5490) plugs and sockets to 
BS 4343 are suitable for use indoors 
where the plug is away from the water 
spray area where the appliance is in 
use.



Never touch the mains plug with wet 

hands.



Do not pull plug while operating the 

device.



Do not run over, crush or pull the 

power supply cord or extension cord, 

otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp 
edges.



Do not use the unit, if the power sup-

ply cord or important parts, e. g. 
high-pressure hose, power gun or 
safety devices are damaged.



Warning: Inadequate extension cords 

can be dangerous.



If an extension cord is used, the plug 

and socket must be of watertight con-
struction. The extension cord must 
have a cross section in accordance 
with the operating instructions and 
be protected against splashed water. 
The connection must not be in water.



When replacing plugs on the power 

supply cable or extension lead the 
spray water guard and mechanical 
stability must remain intact.

Water connection



Comply with the regulations of your 

water supply company.



All connecting hoses must have prop-

erly sealed joints.



Make sure that the supply hose is at 

least 12.7 mm (1/2") in diameter and 
is reinforced.



The appliance should never be used 

on the drinking water supply without 
a back flow valve. Water which has 
passed the back flow valve is regard-
ed as undrinkable.



The high-pressure hose must not be 

damaged (danger of bursting). A 
damaged high-pressure hose must be 
replaced immediately. Only use hos-
es and connections recommended by 
the manufacturer.

OBJ_BUCH-2981-002.book  Page 12  Wednesday, April 26, 2017  3:49 PM