Мойки высокого давления BORT KEX-2500 93720100 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
8
To prevent damage during transport, the appliance is
delivered in a solid packaging which consists largely of
reusable material.Therefore please make use of options
for recycling the packaging.
Problems
Causes
Possible solutions
The machine does not
start
The machine is not plugged in
Connect the machine to a suitable outlet
Defective plug
Change the plug or have your electrical
installation inspected
The fuse is blown
Change the fuse with a similar one
Fluctuations of
pressure
The pump sucks the air
Check that hoses and fittings are waterproof.
Dirty, worn or jammed
Contact your service center
The water supply is not enough
Increase the water pressure, check for blockage
of the hose and / or change the large hose.
Worn out pump seals
The machine stops. The fuse is blown
The fuse is blown
Too small fuse
Replace with a higher fuse.
Increase the amperage
Try without the extension cable
The machine stops
The fuse is blown
Replace the fuse.
Mains voltage incorrect
Disconnect the other machines.
Thermal sensor activated
Check that the mains voltage corresponds to the
specification on the nameplate
The fuse is blown
Too small fuse
Replace with a higher fuse.
Try without the extension cable
Increase the amperage
Pulsation of the
machine
Air in the inlet hose / pump
Let the machine operate with the open trigger
until the working pressure resumes regularly.
Inadequate supply
Increase the water pressure, check for blockage
of the hose or change the large hose
Jet is partially blocked
Clean the jet with a needle and spray some water
toward the rear through the jet
Blocked water filter
Clean the filter
Hose bending
Straighten the hose.
The machine starts and
stops automatically
Leaky shotgun and/or trigger
Contact your nearest service center
The machine starts, but
the water does not come
out
No water supply
Connect the water inlet.
Blocked water filter
Clean the filter
Blocked jet
Clean the jet with a needle and spray some water
toward the rear through the jet
