ADA GroundDrill-16 - Инструкция по эксплуатации - Страница 7

7

English

Excessive pressure on the ground drill can lead to the breakage of the gear 

case, overheating of the engine and its breakdown. Deep the auger drill 

on 20-30 cm and raise it slightly in the hole. Remove earth from the auger 

bit. Don’t take out the whole rotating auger bit from the hole. It can lead to 

the injury. Don’t speed up if the auger bit is jammed in the ground. It can 

lead to the breakage of the gear-wheel of the gear case and the parts of 

the engine. Slow down the engine and disconnect it from the auger bit. Set 

the pivot of appropriate diameter into the hole of pin – release the auger 

bit turning it back.

1. Let engine warm for at least 1 min.

2. Press or release throttle lever to get desired rpms. If the engine reduce

rpms on load, adjust the position of throttle lever.

Important! 

Do not work without workmate. Otherwise it can lead to the 

damages. Avoid running at high rpms for long periods. The unit needs time 

for lubricant to get to all internal parts. Do not run the motor at high rpms 

without load. 

STOPPING

1. Release throttle to idle speed.

2. Move main switch on/off to 0. 

Note: 

When storing for long periods, remove all fuel from the gas tank. Do 

not leave the gas tank at an angle. The pressure inside the tank can cause 

the gas to spill out. The gas can spill out on the hot parts of the engine. it 

can lead to the flame development. 

Elements to checkup/ 

period

Before 

each 

use

First 

month

or 5 Hrs.

Every 3 

months

or 25 Hrs.

(2)

Every 6 

months

or 50 Hrs.

Every 

100 

Hrs.

Oil

check

*

change

*

*

*

Air filter (1)

check

*

clean

*

*

*

Spark plug

check - 

clean

*