KitchenAid KMQCX 45600 - Инструкция по эксплуатации - Страница 10

10

Check that the voltage on the rating plate 
corresponds to the voltage in the home.
Do not remove the microwave inlet protection 
plates located on the side of the microwave oven 
cavity wall. They prevent grease & food particles 
from entering the microwave inlet channels.
Ensure that the microwave oven cavity is empty 
before fitting.
Ensure that the appliance is not damaged. Check 
that the microwave oven door closes firmly against 
the door support and that the internal door seal is 
not damaged. Empty the microwave oven and 
clean the interior with a soft, damp cloth.
Do not operate this appliance if it has a damaged 
mains cord, if it is not working properly, or if it has 
been damaged or dropped. Do not immerse the 
mains cord in water. Keep the cord away from hot 
surfaces.

Electrical shock, fire or other hazards may result.
If the power supply cord is too short, have a 
qualified electrician install an outlet near the 
appliance.
The power supply cord must be long enough for 
connecting the appliance, once fitting in its 
housing, to the main power supply.
For installation to comply with current safety 
regulations, an all-pole disconnect switch with 
minimum contact gap of 3 mm must be used.

Prior to connecting

The appliance can be operated only if the 
microwave oven door is firmly closed.
The earthing of this appliance is compulsory. The 
manufacturer will accept no responsibility for 
injury to persons, animals or damage to objects 
arising from the non-observance of this 
requirement.

The manufacturers are not liable for any problems 
caused by the user’s failure to observe these 
instructions.

After connecting