JVC KD-SH1000 - Инструкция по эксплуатации - Страница 22

22

ENGLISH

  To adjust reproduced frequency 

level—X-Over

This setting is available only when crossover 
network (see page 21) is activated.

1

  Select a filter.

HPF
(Front/Rear)

:  Frequencies lower than the 

selected level are cut-off.

LPF (Rear)

:  Frequencies higher than the 

selected level are cut-off.

2

  Select “On” to activate the selected filter.

•  If you connect high-range speakers to 

Front or Rear output, select “On” for 
the corresponding HPF to prevent the 
speakers from being damaged.

3

  Select a cut-off frequency according to the 

connected speakers.

1.6kHz – 16.0kHz

  :  Front HPF and Rear LPF

31.5 Hz – 200.0Hz

  :  Rear HPF

4

  Adjust the continuity of the sound among 

speakers (slope).

  To adjust subwoofer output—

S.woofer

1

  Adjust the output level.

2

  Select a cut-off frequency according to the 

connected subwoofer.

3

  Adjust the continuity of the sound among 

speakers (slope).

  To adjust the input level of each 

source—Vol Adj

This setting is required for each source except 
for FM. 
Once an adjustment is made, it will be 
memorized. When you change the source the 
volume level will automatically increase or 
decrease according to the adjusted level.

1

  Select a source before entering the SEL 

menu.

2

  Adjust to match the input level to the FM 

sound level.