JVC KD-SH1000 - Инструкция по эксплуатации - Страница 21

21

ENGLISH

Activating crossover network 

By activating crossover network, you can 
allocate different frequency range of sound 
signals to different speakers to match their 
characteristic.

If you have installed the 3-way network 
speaker system in the car, make sure of the 
following:

•  Before using the system, activate crossover 

network and preset the appropriate cutoff 
frequencies for HPF/LPF (especially 
for HPF); otherwise, it may damage the 
speakers.

•  For 3-way network speaker system, see 

Installation/Connection Manual (separate 
volume).

You cannot perform other operations until you 
finish the following procedure.

While the power is turned off...

~

Ÿ

!

• 

To cancel the procedure,

 press and 

hold POWER/ATT/ENTER. The power 
turns off.

⁄

  Finish the procedure.

• 

 indicator 

lights up (in sequence 
with other indicators).

To cancel Crossover,

 repeat the same 

procedure. Make sure that “X-Over Off OK?” 
appears on the display.
• 

 indicator goes off.

Setting the sound modes—SEL 

You can adjust the sound characteristics to your 
preference.

~

  Enter the SEL menu (see page 4).

Ÿ

  Select a setting item.

* 

Appears only when crossover network is 
activated (see left column).

When selecting “Fad/Bal,” “X-Over,” or 
“S.woofer,” press POWER/ATT/ENTER 
to enter its submenu.

!

  Adjust the selected setting item. 

(See the following for details.)

•  To adjust other SEL settings, press 

BACK. Then repeat steps 

Ÿ

 and 

!

.

⁄

  Finish the procedure.

  To adjust fader and balance—Fad/Bal

• 

Fad (fader)

Adjust the front and rear speaker balance.

• 

Bal (balance)

Adjust the left and right speaker balance.