Hyundai Electronics H-CMD7080 - Инструкция по эксплуатации - Страница 13

12

13

Operation

Operation

are used only for rear zone operation).

Please note that for DUAL ZONE mode 

an additional display and an amplifier with 
acoustics should be connected to this unit. Or 
you can use a car TV set with built-in speakers.

AV in jack

AV jack is intended to receive audio and video 

signals by connecting to external device.

Display

Press DUAL/DISP button on the RC to 

display current tuning information and time. 

In Radio mode, display menu: Clock/Time 

=> PTY => Radio Frequency => PS (Program 
Service, if available) => Exit Display.

In Disc/USB/SD mode, except the above 

menu, it will also show ID3 information if the file 
with ID3 tags.

Subwoofer

Press and hold MODE button to enable or 

disable subwoofer. For subwoofer operation an 
external amplifier is required.

Radio operations

Band selection

Press repeatedly BAND button on the panel 

or RDM/BAND button on the RC to select your 
desired radio band in RADIO mode: FM1, FM2, 
FM3, AM1 (MW1), AM2 (MW2). In each set of 
the bands you can store up to 6 preset stations, 
making total 30 preset memory stations.

Manual/automatic tuning

Manual tuning: To find a station, select a 

band first, then press and hold 

/

 buttons 

on the RC until MANUAL appears on the 
display, then press these buttons repeatedly 
to search for the needed frequency upward or 
downward.

Automatic tuning: To find a station, select a 

band first, then press and hold 

/

 buttons 

on the panel or press 

/

 buttons on the 

RC, the automatic downward/upward search 
will start. It will play when a station is found.

Programming preset stations

•   To store a station: Select a band (if 

needed); find a station by manual/automatic 
tuning. Then press MEM button and rotate 
VOLUME knob to choose a memory position 
(1-6), and finally press OK button to confirm. 
Or, after finding a station, press and hold a 
number button (1-6) on the RC to save the 
station in the corresponding memory position.

•   To recall a station: Select a band (if 

needed); press MEM button on panel, then rotate 
VOL knob to choose (1-6), and finally press OK 
button to confirm the needed station. Or press a 
number button (1-6) on the RC to call the station 
saved in the corresponding position.

Auto memory store

Select a band, press and hold RPT/P.SCAN 

button on the RC to enter auto store mode. 
The radio will automatically store 6 stations to 
the 6 preset memories of the current band. To 
stop auto store, press this button again.

  During auto station preset, the unit will 

search and store stations with the strong signal 
first, and then weaker signal stations until the 
memories are full.

Preset scan

Select a band, press RPT/P.SCAN button 

on the RC to scan all preset stations in the 
memories of the current band, each preset 
scan for 5 seconds. To stop preset scan, press 
the button again.

RDS function

RDS (Radio Data System) service availability 

varies with areas. Please understand if RDS 
service is not available in you area, the 
following service is not available, either.

AF (Alternative Frequencies) 

function

Press and hold MEM button on the front