Hyundai Electronics H-CMD4030 - Инструкция по эксплуатации - Страница 12

12

13

Operation

Operation

unit. This enables to adjust the volume and 
quality of the sounding. For example, you can 
connect an MP3-player to listen to tracks using 
the car acoustic system.

Radio operations

Band selection

Press repeatedly BAND button on the panel 

or RDM/BAND button on the RC to select your 
desired radio band in RADIO mode: FM1 - FM2 
- FM3 (OIRT) – MW1 (AM1) - MW2 (AM2). In 
each set of the bands you can store up to 6 
preset stations, making total 30 preset memory 
stations.

Manual/automatic tuning

•  Manual tuning: Press and hold SEEK- 

/

SEEK+ 

 buttons on the RC to enter manual 

tuning mode. MANUAL will be displayed. 
Press these buttons repeatedly to change the 
frequency upward or downward step by step.

•  Automatic tuning: Press repeatedly 

SEEK- 

/SEEK+ 

 buttons on the RC or 

press and hold these buttons on panel to start 
automatic seeking for an available radio station 
downward or upward. After being found the 
station will be played. To stop seeking, press 
one of these buttons again.

Programming preset stations

•  There are 6 numbered preset buttons on 

the RC, with which you can store and recall 
stations for each band (18 FM, 6 AM). Select 
a station, then press and hold a preset button. 
The station will be saved in the memory under 
the corresponding number. To recall a stored 
station, press the corresponding preset button.

•  You also can save stations in the memory 

with MEM button on the front panel. When 
the needed frequency is found, press MEM, 
then rotate VOLUME knob to select a memory 
position (Preset 1 - 6) and press OK button to 
confirm saving.

Auto memory store/Preset scan

Auto store: Select a band, press and hold 

P.SCN/RPT button on the RC to enter auto 
store mode. The radio will automatically store 6 
stations to the 6 preset memories of the current 
band. To stop auto store, press the button again.

  During auto station preset, the unit will 

search and store stations with the strong signal 
first, and then weaker signal stations until the 
memories are full.

Preset scan: Select a band, press P.SCN/

RPT button on the RC to scan all preset 
stations in the memories of the current band. 
To stop preset scan, press the button again.

Stereo/Mono reception

In FM mode, press STEREO/MONO button 

on the RC to select stereo or mono signal 
reception mode. 

On-screen display

Press OSD button on the RC to show 

enabled PTY function icon.

RDS function

RDS (Radio Data System) service availability 

varies with areas. Please understand if RDS 
service is not available in you area, the 
following service is not available, either.

AF (Alternative frequencies) function

Press and hold AF/TA button on the RC 

or MENU button on the panel to enable AF 
function. When the radio signal strength is poor, 
enabling the AF function will allow the unit to 
automatically search another station with the 
same PI (Program Identification) as the current 
station but with stronger signal strength.

  AF indicator on the display will flash until 

RDS information is received. If RDS service is 
not available in your area, turn off the AF mode.

TA (Traffic alarm) function

Press AF/TA button on the RC or press and 

hold OK button on the panel to activate the 
traffic alarm function.