Hyundai Electronics H-CMD4030 - Инструкция по эксплуатации - Страница 10

10

Operation

  If turn off the power, all the settings 

of each mode will be saved. If turn off the 
ACC power, all the settings will be clear and 
become factory default setting. If you don’t 
adjust setting within several seconds after 
selecting the desired setting item, the unit will 
automatically return to the current mode.

  If Flat, Classic, Pop or Rock equalizer 

mode is selected, treble and bass are not 
adjustable. For operation with Beep and 
Loudness see below System Setup paragraph.

System setup

Press MENU button on the panel or SETUP 

button on the RC to enter Setting Menu. Press 
UP/DOWN cursor buttons on the RC or rotate 
VOLUME knob on the panel to select a menu 
page. Press ENTER button or RIGHT cursor 
button on the RC or press OK button on the 
panel to enter the page. Press UP/DOWN cursor 
buttons on the RC or rotate VOLUME knob on 
the panel to select an item, then press ENTER 
button on the RC or OK button on the panel to 
adjust the setting.

SOUND page
•  EQ: Select Flat, Classic, Pop, Rock or 

User equalizer mode.

•  Bass: Adjust the low-frequency level.
•  Treble: Adjust the hogh-frequency level.
•  Balance: Adjust the balance between left 

and right channels.

•  Fader: Adjust the balance between front 

and left channels.

•  Volume: Adjust the sound volume level.
•  Beep: Select ALL (beep is heard at any 

button pressing), 2ND (beep is heard when a 
button is pressed and held) or OFF (no beep).

•  Loudness: Selecting loudness ON will 

emphasize the low frequency output.

DISPLAY page
•  Screen: Select 16:9, 4:3 or FULL screen 

modes.

•  Backlight: select LOW, MID or HIGH 

display backlight level.

RADIO page

General operations

Reset the unit

Operating the unit for the first time or after 

replacing the car battery, you must reset the 
unit. Press RESET button (hole) with a pointed 
object (such as a ballpoint pen) to set the unit 
to initial state.

  When some errors occur, you can also 

press RESET button to resume to normal, 
and it will erase the clock setting and some 
memorized functions.

Turning on/off

Press any button on the panel or the RC 

(except OPEN button) to turn on the unit. Press 
and hold PWR/MUTE button on the panel or 
press POWER button on the RC to turn off the 
unit.

Volume control

Rotate VOLUME regulator or press VOL+/

VOL- buttons on the RC to adjust the volume 
level.

Mute function

Press PWR/MUTE button on the panel or 

MUTE button on the RC to turn the sound off. 
“MUTE” will be displayed. Press this button 
again or adjust the volume to turn the sound on.

Setting the sound characteristics

Press SEL button on the RC to call setting 

menu consisting of following items: EQ => 
BASS => TREBLE => BALANCE => FADER 
=> VOLUME => BEEP => LOUDNESS. Press 
UP/DOWN cursor buttons on the RC or rotate 
VOLUME knob on the panel to select the audio 
setting item. Press ENTER button or RIGHT 
cursor button on the RC or OK button on the 
panel to enter the selected item.

Press LEFT/RIGHT buttons on the RC or 

rotate VOLUME knob on the panel to adjust the 
audio setting. Press SEL button on the RC again 
to save the setting and return to current mode.