Hyundai Electronics H-CCR2701G - Инструкция по эксплуатации - Страница 4

4

Before you start

Installation

General notes

•   Choose the mounting location where the 

unit will not interfere with the normal driving 
function of the driver.

•   Before finally installing the unit, connect 

the wiring and make sure that the unit works 
properly.

•   Consult with your nearest dealer if 

installation requires the drilling of holes or other 
modifications of the vehicle.

•   Install the unit where it does not get in the 

driver’s way and cannot injure the passenger if 
there is a sudden stop, like an emergency stop.

•   If installation angle exceeds 35° from 

horizontal, the unit may not perform properly.

•   Avoid installing the unit where it would 

be subject to high temperature, such as from 
direct sunlight, or from hot air, from the heater, 
or where it would be subject to dust, dirt or 
excessive vibration.

Mounting

•   Connect the cable set and the antenna to 

the vehicle’s electronics corresponding to the 
connection table (see farther).

•   Attach the mounting racks to the sides 

and to the back of the unit, and fix them with 
the screws.

•   Insert the unit into the slot until the stop. 

The unit then audibly snaps.

•   Fasten the screws to fix the unit.
•   The device is distinguished by a high 

degree of output. During operation, this results 
in a strong heat generation. Therefore no 
cables or other parts may adjoin the device. If 
their insulation melts, there is the risk of a short 
circuit or fire.

•   Removing: Turn off the device. Clamp off 

the negative pole of the vehicle battery for the 
duration of the disassembly. Unscrew the four 
screws. Remove carefully the unit from the slot 
and disconnect all wires. Make sure that no 
vehicle cable can cause a short circuit after the 
device has been unplugged.