Husqvarna 122HD60 - Инструкция по эксплуатации - Страница 12

STARTING AND STOPPING

12 – English

Check before starting

•

Inspect the working area. Remove any objects that 
could be thrown out.

•

Check the cutting attachment. Never use blades that 
are dull, cracked or damaged.

•

Check that the machine is in perfect working order. 
Check that all nuts and screws are tight.

•

Make sure the gear housing is lubricated correctly. 
See instructions under the heading Gear housing.

•

Check that the cutting attachment always stops when 
the engine is idling.

•

Only use the machine for the purpose it was intended 
for.

•

Make sure that the handle and safety features are in 
good working order. Never use a machine that lacks a 
part or has been modified outside its specifications.

•

All covers must be correctly fitted and undamaged 
before you start the machine.

Starting and stopping

Cold engine

Choke:

 Set the choke control in the choke position.

Primer bulb:

 Press the air purge diaphragm repeatedly 

until fuel begins to fill the diaphragm (about 6 times). The 
diaphragm need not be completely filled.

Starting

Hold the body of the machine on the ground using your 
left hand (CAUTION! Not with your foot!). Grip the starter 
handle, slowly pull out the cord with your right hand until 
you feel some resistance (the starter pawls grip), now 
quickly and powerfully pull the cord. 

Never twist the 

starter cord around your hand.

Push the choke control back to its original position as 
soon as the engine fires, and continue trying to start until 
the engine starts. 

CAUTION! 

 When the choke control is pushed back to its 

original position, the engine runs at a heightened speed, 
the so called start throttle position, and the blades then 
move. Start throttle position is released by throttling using 
the throttle lever.

CAUTION! 

 Do not pull the starter cord all the way out and 

do not let go of the starter handle when the cord is fully 
extended. This can damage the machine.

!

WARNING! The complete gear housing 
must be fitted before the machine is 
started, otherwise the clutch may loosen 
and cause personal injury.

Always move the machine about 3 
metres from the refuelling position 
before starting. Place the machine on a 
firm surface. Remember that the blades 
may start to move when the engine is 
started. Make sure the blades cannot 
come into contact with any object. Make 
sure that no unauthorised persons are in 
the working area, otherwise there is a 
risk of serious personal injury. The safety 
distance is 15 metres.

H1153993-26,122HD45,60#4ACBF.fm  Page 12  Tuesday, January 4, 2011  8:31 AM