Кусторезы Fieldmann FZN4002-B - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
EN
PETROL-POWERED HEDGE TRIMMER
USER'S MANUAL
17
Using the hedge trimmer - trimming
CUTTING IN THE VERTICAL DIRECTION
Cut in an aching motion from the bottom part upwards
and then downwards, utilising both sides of the
blades.
Fig. 7
CUTTING IN THE HORIZONTAL DIRECTION
Tilt the blades slightly towards the cutting direction
(at an angle of 5 - 10°) in order to achieve the best
possible trimming results.
Fig. 8
KICKBACK AND RELEVANT WARNINGS
Kickback is a sudden reaction to a blockage or jamming of the work tool. A blockage or jamming causes the
rotating equipment to stop suddenly, which subsequently causes uncontrolled movement of the tool in the
opposite direction to the rotation direction of the equipment in the location of the blockage. For example, if the work
tool is blocked or jammed by a stone, the edge of the work tool entering the area where it is clamped, may enter
the surface of the material, which may cause the work tool to rise or kickback. The work tool may jump towards
the user or away from the user depending on the movement direction of the work tool at the point of its blockage.
Recoil is the result of incorrect use of the power tool, incorrect work procedure or unsuitable operating conditions
and kickback may be prevented by adherence to the instructions provided below.
a)
Always maintain a fi rm grip on the power tool and maintain such a body and arm
position to resist a kickback force.
b)
Never place your hands in the vicinity of a rotating blade.
The blade may be defl ected
backwards over your hands.
c)
Do not stand on such places, into which the power tool would be defl ected in the
event of kickback.
Kickback will fl ing back the power tool in the opposite direction to the movement of
the power tool in the location of its blockage.
d)
Be very careful when working near corners and sharp edges, etc. You will prevent the
blade from jumping and jamming.
Corners, sharp edges or jumping of the blade have a tendency
to jam the rotating blade and cause loss of control or kickback.
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
