Fieldmann FZN4002-B - Инструкция по эксплуатации - Страница 15

EN

PETROL-POWERED HEDGE TRIMMER

USER'S MANUAL

15

CHECKING THE AIR FILTER

  Check the air fi lter to be sure that it is clean and in good condition.
  Loosen the bolt on the air fi lter cover, remove this cover and then check the fi lter. If necessary, clean or 

replace the fi lter.

6. STARTING THE ENGINE

WARNING!

The trimmer blades may move when starting the engine. 

Make sure that the trimmer blades cannot come into contact with any object. Make 
sure that there are no unwanted persons in the work area. These persons would be 
subject to a risk of serious injury.

STARTING A COLD ENGINE

Fig. 4

Fig. 5

1.   Set the engine switch to the ON position (Fig. 4, point 1)
2.   Press the fuel primer bulb (Fig. 5, point 1) several times.
3.   Set the choke lever to the CLOSE position (see Fig. 5, point 2)
3.  Place the hedge trimmer fl at on the ground so that it is stable and pull on the handle of the starting cord 

until the engine shows signs of attempting to start. Initially pull the starter winding cord slowly until you feel 
resistance and then pull on the cord strongly. Hold the cord as it winds back into the starter and allow it to 
wind on gently and slowly.

4.   At this point, set the choke lever back to the OPEN position (Fig. 5) and start the engine by repeatedly pulling 

on the starting cord.

ATTENTION! 

Spinning the engine for too long with the choke lever in the CLOSE position will result in 

fl ooding of the engine and problems with starting it up.

5. Prior to starting work, leave the engine to warm up for a few minutes to get up to operating temperature.

Before using 

|

 Starting the engine