AL-KO COMBI CARE 38 Р COMFORT - Инструкция по эксплуатации - Страница 13

Startup

474398_b

13

In case the cutting height is not correct:

the scarifier stands still
the engine does not pull through

IIn this case, set the knob to a lower cutting height.

ADVICE

Before mowing the lawn scarifying fore-

ver.

Starting the engine

Starting with a cold engine, after longer periods of

storage and temperatures under 10°C:
1. Press pimer button “a” 6 times. 

(picture K)

.

2. Press pimer button “b” 10 times. 

(picture K)

.

3. Press control button and simultaneously pull

engine bar up to handle bar and hold it there

(picture L)

.

ADVICE

You  must  hold  the  engine  control  bar

tight during use.

4. Quickly pull out the starter cord and then allow

it to slowly roll up 

(picture M)

.

5. Let the engine run until it is warm.

ADVICE

Do not press primer buttons when en-

gine is warm.

Engine  speed  (rpm  value)  is  fixed.  En-

gine speed cannot be adjusted.

Turn the engine off

1. Release the control bar

 (picture L)

.

WARNING!
Risk of injuries due to turning spind-

les!

The cutter spindle does not stop turning

immediately. Do not touch the bottom of

the equipment shortly after switching off.

Installing and removing the grass catcher

1. Turn the engine off before installing/removing

the grass catcher.

2. Wait  until  the  cutter  spindle  has  come  to  a

complete stop!

General operation instructions

To start the equipment, the cutting unit must

be freely movable.
Keep  hands  and  feet  away  from  rotating

parts.

Control  the  equipment  only  through  the

handle.  Thus  the  safety  distance  is  guaran-

teed.
Keep exhaust and engine clean.
Always ensure you have a good foothold on

slopes.
Move across slopes, never up or down.
Do not use on steep slopes.
Guide the machine at walking pace.
Never tilt or transport the device with the en-

gine running.
Have a professional check:

after bumping against an obstacle
if the engine stops suddenly
if the blade is bent
if the cutter spindle is bent
if the belt is damaged.

MAINTENANCE AND CARE

DANGER!

Risk of injury at the cutter spindle. Wear

protective gloves!

Remove the spark plug connector before any

maintenance or cleaning jobs!
Do not spray water on the equipment! Water

infiltration  (ignition  system,  carburetor)  can

cause faults.
Clean the equipment after each use (spatula,

cloth).

Removing the scarifier roller

 (picture N)

1. Remove the bearing screw (1).
2. Tilt the bearing halves (2) upwards.
3. Lift the scarifier roller from the lower bearing

half and extract it out from the drive side (3).

Assembly is carried out in reverse order.

Removing the aerating roller

Removal of the aerating roller and replacement of

steel spring hooks are similar to scarifier roller.

Removing the blades 

(picture O)

ADVICE

Before removing the blades observe the

mounting position!

1. Unscrew the hexagonal bolt (1).
2. Carefully remove the ball bearing (2) from the

spindle (8).