Timberk AC TIM 07H P4 - Инструкция по эксплуатации - Страница 9

www.timberk.com • Electric air conditioner

9

Fig. 10

8. MAINTENANCE

IMPORTANT! 

Disconnect the unit from the mains prior to cleaning.

1. When cleaning the air conditioner, do not use gasoline, solvents and 

other chemically active substances.

2. To avoid electric shock and damage to electrical components, do not 

pour water on the air conditioner from a tap or a hose. 

3. Do not use the air conditioner if the power cord is damaged. On the 

subject of replacing a damaged power cord, contact an authorized 

service center.

Fig. 11

Installation of the filter is performed in the reverse order.

Filter cleaning

At first, carefully clean the filters by means of vacuum cleaners. Then 

immerse the filter in warm water (about 40°C) with a soft detergent, 

wash it and dry it without exposure to direct sunlight.

Air intakes (heat exchangers)

Use a vacuum cleaner for cleaning.

Case

Wipe the surface by a damp cloth and dry it by a soft dry cloth.

Automatic condensate removal

Condensate is automatically removed from the unit. Moisture inside 

the unit starts to evaporate and is removed from the unit through an 

air duct (or an air diffuser) in the form of steam.

«E4»  signal  is  shown  on  the  LED  display  at  the 

maximum  water  level  (for  AC  TIM  09HE  P4).  As 

for  AC  TIM  07H  P4  and  AC  TIM  09H  P4    “FULL”   

indicator is on in this case.
To resume the operation, remove the rubber plug 

(2) of the drainage hose to drain water at first. After 

water is drained, turn the unit on, the unit will resume 

operation.

Fig. 10.

Fig. 11.

Air filter.

Air filter clogging with dust particles impairs the air conditioner operation 

efficiency, therefore clean the filter no less than once in two weeks.

Filter removal/installation

Remove the air filter in the direction, indicated by the arrow. Slightly 

push it and then take it out from the device for cleaning. (See Fig. 11 ).