Timberk AC TIM 07H P4 - Инструкция по эксплуатации - Страница 8

www.timberk.com • Electric air conditioner

8

remote control (only for AC TIm 09He P4

5

7

6

3

4

1

9

8

Fig. 9

1. FUNC mode selection button (SET):
You can select three functions with this button: cooling, heating and 

dehumidification.
2. Room temperature setting button (TEMP): The set temperature is 

raised by 1°C after a single press on “up” button and is lowered by 1°C 

after a single press on “down” button. 3. POWER button: pressing this 

button you can switch on or off the unit.
4. SLEEP button: after pressing this button the fan sets to low speed.
(1) Press SLEEP button, set the sleep mode. Press the button again to 

cancel the sleep mode.
(2) In the cooling mode one hour after the sleep mode is set the 

temperature automatically increases by 1°C. In two hours the 

temperature will increase by 2°C and the established mode is 

maintained for the rest of the time. In the heating mode when SLEEP 

function is activated the temperature is, on the contrary, decreased by 

2°C in 2 hours.
(3) When power supply is turned off, the sleep mode is automatically 

switched off.
(4) When the unit is turned off, settings of the sleep mode are 

automatically turned off.

The unit can evaporate condensed water and 

automatically drain it through the hose.
1.When the unit is in cooling mode, it is not 

necessary to install the condensate drainage pipe 

since condensate evaporates automatically. Make 

sure that when the unit is operating, the rubber plug 

of the drainage hose is securely fixed (see Fig. 0).
2.In heating mode, remove the rubber plug (2) of 

the drainage hose (Fig. 10), install the respective 

drainage hose to improve heating efficiency.
3.In dehumidification mode, remove the rubber 

plug (2) of the drainage hose, install the respective 

drainage hose.
Disconnect the air outlet hose, connect the 

drainage hose to the drainage hole and drain water 

from the unit to ensure maximum dehumidification 

efficiency.

5. Timer button: ON TIMER: The ON timer is used to automatically 

switch on the unit upon expiration of the set time.
(1) Press TIMER button when the unit is OFF to set the desired time.
(2) After the set time expires, the unit will be automatically switched on.
(3) Press ON/OFF button before the set time expires. Time setting will 

be canceled and the unit will be switched on.
OFF TIMER: The OFF timer is used to automatically switch off the unit 

upon expiration of the set time.
(1) Press TIMER button when the unit is ON to set the desired time.
(2) After the set time expires, the unit will be automatically switched off.
(3) Press ON/OFF button before the set time expires. Time setting will 

be canceled and the unit will be switched off.
6. Automatic fan speed button (automatic ventilation mode).
7. High speed button. High fan speed.
8. Medium speed button. Medium fan speed.
9. Low speed button. Low fan speed.

Fig. 9.