Krups EA82F010 Quattro Force - Инструкция по эксплуатации - Страница 29

24

You can stop your appliance at all times: the appliance will emit two beeps and then it will 
stop soon afterwards.

PROBLEMS AND CORRECTIVE ACTIONS

PROBLEMS

CORRECTIVE ACTIONS

The appliance does not 
switch on when the “On/Off” 
is pressed.

Check that the plug of the power cord is pushed 
correctly into the mains socket.

Water or steam comes 
incorrectly out of the steam 
nozzle.

In case of repeated operation, several drops may drip 
from the steam nozzle.

The espresso or coffee is not 
hot enough.

Change the coffee temperature setting.
Heat the cups by rinsing them with hot water.

The coffee is too light or not 
strong enough.

Check that the coffee bean tank has coffee in it and that 
it is flowing correctly. Avoid using oily, caramelised or 
flavoured coffee.
Reduce the volume of coffee using the central knob.
Turn the grinding fineness knob towards the left for 
a finer grind. Prepare in two cycles using the 2 cup 
function.

The coffee flows too slowly.

Turn the grinding fineness knob towards the right for a 
coarser grind (may depend on the type of coffee used).
Carry out one or two rinsing cycles.

The coffee is not creamy 
enough.

Turn the grinding fineness knob towards the left for a 
finer grind (may depend on the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow 
the installation procedure on page 13).
Carry out one or two rinsing cycles.

The appliance does not serve 
any coffee.

An incident has been detected during the preparation. 
The appliance resets itself automatically and is then 
ready for a new cycle.

Why can I not run descaling/
why does my machine not 
request a descaling cycle?

The machine only requests a descaling cycle once it has 
made a certain number of drinks using steam.

You have used ground coffee 
instead of bean coffee.

Use your vacuum cleaner to suck out the pre-ground 
coffee in the coffee bean tank.

The grinder makes a strange 
noise.

There are foreign particles in the grinder. Contact 
KRUPS’ Customer Service.

The grinding fineness knob is 
hard to turn.

Only change the grinder setting when it is operating.