Krups EA82F010 Quattro Force - Инструкция по эксплуатации - Страница 24

19

ENGLISH

now prepared your appliance. The drink select menu will be displayed.
Put two cups under the coffee outlets. You can lower or raise the coffee outlets to suit the 
size of your cups.- 

Fig. 17

. Select your drink and confirm by clicking twice on the 

OK

 key.

A message will appear to tell you that you have chosen two cups.

The appliance will automatically sequence 2 complete coffee-making cycles.

PREPARING HOT WATER

While the screen displays the drink selection menu, press the “hot water” key  .
A message will invite you to place a container under the steam nozzle. Again press the “hot 
water” key   to produce hot water - 

Fig. 14

.

To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum amount of hot water per cycle is limited to 300 ml.

PREPARING STEAM

Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats 
up liquids. As you need a higher temperature to produce steam than to make an espresso, 
the appliance runs an additional pre-heating phase for steam.
While the screen displays the drink selection menu, press the “steam” key   - 

Fig. 18

. A 

screen will inform you that the appliance is being pre-heated. Once the pre-heating phase 
has been completed, a message will ask you to place a container under the steam nozzle 
- 

Fig. 5

. Press the “steam” key   again to start generating steam. A little water will be 

produced first and then steam will start. Use the same key to stop steam generation.

BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.

Frothing milk

We recommend that you use pasteurised or UHT milk that has been recently opened. 
Do not use untreated milk. After the steam function has been used, the nozzle will be 
hot, and we recommend that you wait for a few moments before handling it.

Check that the steam nozzle is correctly fitted - 

Fig. 19

.

Pour the milk into your milk jug. Only half fill it. Immerse the nozzle in the milk - 

Fig. 20

. 

Press the “steam” key   and follow the instructions on the screen.
Once your milk is frothy enough… - 

Fig. 21

, again press the “steam”   key to stop the 

cycle. Be careful, because the cycle does not stop immediately.
To remove any remaining milk from the steam nozzle, place a container under the nozzle 
and press the “steam” key   . Let the hot water escape for at least 10 seconds and then 
again press the “steam” key   to stop water.
You can remove the steam nozzle for thorough cleaning. Wash it using a brush with water 
and a little non-abrasive washing up liquid. Rinse and dry it - 

Fig. 22-23

. Before re-fitting, 

make certain that the air inlet holes are not clogged by milk residues. Clean out the holes 
with a needle if necessary - 

Fig. 24

.