Krups EA8250PE Compact Espresseria - Инструкция по эксплуатации - Страница 30

25

ENGLISH

PROBLEMS

CORRECTIVE ACTIONS

The steam does not come 
out of the nozzle.

After switching off your appliance and leaving it to cool:
Make sure the tip of the steam nozzle is properly 
affixed. Make sure the steam nozzle is not clogged at 
the aerator (if necessary clean the steam nozzle aerator 
with the needle supplied). Empty the tank and remove 
the Claris filter. Fill the tank with mineral water high in 
calcium (> 100 mg/litre or .015oz/gallon), it may take as 
many as 5 to 10 cycles of steam at 60 seconds each 
cycle to achieve a continuous jet of steam.

There is not enough milk 
froth.

Using the needle supplied unblock the small air inlet at 
the top of the nozzle if required.
Use a cold container and milk that has been opened 
recently.
Try changing the type of milk if this does not work (UHT 
or pasteurised).

The milk froth is too bubbly.

Check that the two ends of the small stainless steel 
tube are fitted correctly into the flexible part of the 
steam nozzle.

The Auto-Cappuccino 
accessory does not suck 
the milk (accessory sold 
separately).

Ensure that the tube immersed in the milk is not 
blocked.
Check that the flexible tube is not twisted and that it is 
correctly fitted into the accessory to avoid any air being 
sucked in.
After switching off your appliance and leaving it to cool, 
unblock the outlet of the Auto-Cappuccino accessory.

After emptying the coffee 
grounds collector, the 
warning message is still 
displayed on the screen.

Correctly replace the coffee grounds collector and 
follow the instuctions on the screen. Wait at least 6 
seconds before replacing them.

The power has been cut off 
during a cycle.

The appliance resets itself automatically when the 
power is switched back on and is ready for a new cycle.

There is water or coffee 
underneath the appliance.

The drip collector tray has overflowed: empty it and 
clean the coffee grounds collector. Check that the drip 
tray is fitted correctly.
Do not remove the water tank before the end of the 
cycle.

A message   appears.

Unplug the appliance for 20 seconds, remove the Claris 
cartridge and if required, put it back into service.
If the fault persists, note the fault number and contact 
KRUPS’ Customer Service.

If coffee flows behind the 
coffee nozzles.

Pour cold or room-temperature water into the tank. 
Reduce the temperature level.