Krups Arabica Espresso (EA811010) - Инструкция по эксплуатации - Страница 22

22

4. Info (number of cycles)

The light 

 comes on.

To go to the next stage, press the 

 button. You will go back to adjustment 1.

To leave settings mode, press 

.

  At any of these stages, you can leave settings mode by pressing the 

 button if you have finished your adjustments. All 

of the lights will go off. These settings stay applicable even if there is an electric power cut. You can change these settings 
at any time by repeating these operations.

TROUBLESHOOTING, CORRECTIVE ACTIONS

PROBLEM MALFUNCTION

CORRECTIVE ACTION

Your appliance detects a fault.

Switch off and disconnect the appliance, remove the fil-

ter cartridge, wait for a minute and restart the appliance.

The appliance does not turn on when the 

 button is 

pressed.

Check your fuses and plug sockets.

Check that the two power plugs are correctly pushed in 

the socket.

The coffee grinder makes a strange noise.

There is a foreign body in the grinder. Disconnect the 

appliance before investigating. See if you can extract 

the foreign body using your vacuum cleaner.

The steam nozzle makes a noise.

Check that the steam nozzle is correctly attached to its 

corresponding end piece.

The steam nozzle on your appliance seems partially or 

completely clogged.

Ensure that the opening in the end piece is not ob-

structed by milk residue or limescale. Unclog the holes 

with the needle supplied with your appliance.

The steam nozzle makes little or no milk froth.

For milk-based drinks, use very fresh, very cold pas-

teurised or UHT milk. It is also advisable to use a cold 

container. If the results do not improve, try changing the 

brand of milk.

No steam comes out of the nozzle.

Empty the tank and temporarily remove the filter car-

tridge. Fill the water tank with mineral water which is 

high in calcium (> 100 mg/l) and run successive steam 

cycles.

The auto-cappuccino set makes little or no froth.

The auto-cappuccino set does not take in milk.

Check that the accessory is correctly attached to the 

appliance, remove it then replace it.

Check that the flexible tube is not obstructed or pierced 

and that it is correctly attached to the accessory so as 

to make it airtight. Rinse and clean the accessory (refer 

to the “Auto-cappuccino accessory” chapter).

There is water underneath the appliance.

Before removing the water tank, wait for 15 seconds 

after the coffee has finished flowing so that the appli-

ance finishes its cycle properly.

Check that the drip tray is correctly positioned on the 

appliance; it should always be in place, even when the 

appliance is not in use.

Check that the drip tray is not full.

The drip tray should not be removed during a cycle.

Clean the tank and its connection regularly to avoid the 

build up of scale, which can cause leaks.

After emptying the coffee grounds collector, the warning 

message is still displayed on the screen.

Remove the coffee grounds collector and ensure it is 

empty and clean. Wait at least 6 seconds before replac-

ing, and ensure it is correctly installed.