Neff C17KS61G0 - Инструкция по эксплуатации - Страница 41

 41

en

Initial use

E

Touch 

E

 to open the selection of service 

programmes. Run the desired programme 

as described in the section “Service 

programmes”.

Double

G

Touch 

G

 after selecting a drink to 

prepare two cups simultaneously (see the 

section “Two cups at once”).

My Coffee 

B

Touch 

B

 to open the selection of “Per-

sonalised beverage preparation”. Personal 

settings for coffee drinks can be saved and 

called up (see the section “Personalised 

drinks”). 

C

Touch 

C

 for either beverage preparation 

or to launch a service programme. 

If you touch 

C

 again while the drink is 

being prepared, dispensing will be prema-

turely halted.

Arrow navigation button

Press the arrow on the arrow button to navi-

gate in the display or to change parameters.

Display

The display shows drinks, settings and 

information (see the section “Display”).

Initial use

General

Fill the appropriate container using only 

pure, 

cold

, uncarbonated water and solely 

roasted

 beans. Do not use coffee beans 

that have been glazed, caramelised or 

treated with other additives containing 

sugar, since they will block the brewing unit. 

A

Before the appliance can be 

switched on and used, it must 

be assembled and connected 

according to the enclosed assembly 

instructions.

Setting up the appliance

■ Remove any protective plastic film.

F

Important:

 Only use the appliance 

in a frost-free room. If it has been 

transported or stored at tempera-

tures below 0°C, wait at least 3 hours 

before initial use.

■

Take hold of the appliance door by the 

recessed grip and open.

■ Remove the water tank, rinse it and fill it 

with fresh water up to the “max.” mark.

■ Replace the water tank and click into 

place.

■ Remove the bean container, fill with 

coffee beans and replace.

■

Set the mains switch to 

I

 and close 

the appliance door. 

The appliance heats up and is rinsed. 

The display is activated. 

“Please set your preferred language.”

appears.

■

Press the 

M

arrow button. The field 

“Deutsch”

 has a light background. The 

language can be changed.

■

With the 

L

 arrow button select the 

desired language.

■

Press the 

N

 arrow button. The field 

“Language”

 has a light background.

■

Select the 

“Water hardness”

 with the 

L

arrow button.

F

It is important to set the water hard-

ness correctly to enable the appli-

ance to accurately indicate when the 

descaling programme should be run. 

The preset water hardness is level 

4.If a water softener is installed in 

the house, please set the water hard-

ness to level 3. You can also check 

the water hardness by asking your 

local water supplier.

■

Use the enclosed test strip to determine 

the water hardness. Briefly dip the test 

strip in water and check the result after 

one minute.