Bosch TES80721RW VeroSelection 700 - Инструкция по эксплуатации - Страница 27

23

TES80.. | 04/2013

en

Pl ace 1 l container 

Pl ace suction pipe in container 



start

●

Place a container with a capacity of at 

least 1 l under the milk frother 

10

.

●

Place the end of the suction pipe 

10d

 in 

the container.

●

Press the 

start

 button 

8

. The appliance 

rinses twice.

Cleaning 

Open powder compartment

●

Open the powder compartment 

18

.

Insert Bosch cleaning tablet  

and close drawer

●

Drop a Bosch cleaning tablet in the 

drawer 

18

 and close.

Remove filter 



start

Info: 

If the water filter 

29

 is activated, the 

display will prompt you to remove the filter 

29

, then press the 

start

 button 

8

 again.

Add 0.5 l water and descaler 



start

●

Pour lukewarm water into the empty water 

tank 

11

 up to the “

0.5 l

” mark and then 

dissolve two Bosch descaling tablets in it.

●

Press the 

start

 button 

8

. The  descaling 

programme now runs for about 

20 minutes.

Descaling

Not enough descaling fluid.  

Refill fluid 



start

Info: 

If there is not enough descaling solu-

tion in the water tank 

11

, the corresponding 

prompt is displayed. Pour in descaling solu

-

tion and press the 

start

 button 

8

 again.

Clean and refill water tank  



start

●

Rinse the water tank 

11

 and refill it with 

fresh water up to the “

max

” mark.

●

Press the 

start

 button 

8

. The descaling pro

-

gramme now runs for about 1 minute more, 

followed by the cleaning programme for 

about 7

minutes, and rinses the appliance.

Descaling

Cleaning

Empt y drip tray  

Repl ace drip tray

●

Empty the drip tray 

23 

and reinsert it.

Replace the filter if one is being used. The 

appliance has completed descaling and 

cleaning and is ready for use again.

Important:

 Wipe down the appliance using a 

soft, damp cloth to immediately remove any 

descaler residue. Such residue can cause 

corrosion. New sponge cloths may contain 

salts. Salts can cause rust film on stainless 

steel and must therefore be washed out 

 thoroughly before use.

Thoroughly clean the suction pipe 

10d

 of 

the milk frother.

Note:

 If one of the service programmes is 

interrupted, e. g. by a power outage, pro

-

ceed as follows:

●

Rinse the water tank 

11

 and refill it with 

fresh water up to the “

max

” mark.

●

Press the 

start

 button 

8

. The cleaning 

programme now runs for about 3 minutes, 

and rinses the appliance.

Cleaning

Empt y drip tray  

Repl ace drip tray

●

Empty the drip tray 

23 

and reinsert it.

The appliance is ready for use again.

TES803_805_807_1RW.indb   23

08.05.2013   14:53:03