Bosch TES80721RW VeroSelection 700 - Инструкция по эксплуатации - Страница 25

21

TES80.. | 04/2013

en

Descaling

Duration: approx. 30 minutes. 

Cleaning and service 
Descale 



start

Clean 

The 

start

 button 

8

 flashes while the different 

descaling processes are running.

The figures on the top right indicate the 

progress of the programme.

Important:

 If there is a water filter 

29

 in 

the water tank 

11

, it needs to be removed 

before the service programme is run.

●

Press the 

à

 button 

3

.

Descale 



start

●

Press the 

start

 button 

8

; the display 

5

 will 

guide you through the programme.

Empt y drip tray  

Repl ace drip tray

●

Empty the drip tray 

23

 and reinsert it.

Pl ace 1 l container 

Pl ace suction pipe in container 



start

● Place a container with 1 litre capacity

 under 

the milk frother 

10

.

●

Place the end of the suction pipe 

10d

 in 

the container.

●

Press the 

start

 button 

8

.

Remove filter 



start

Info: 

If the water filter 

29

 is activated, the 

display will prompt you to remove the filter 

29

, then press the 

start

 button 

8

 again. 

Add 0.5 l water and descaler 



start

●

Pour lukewarm water into the empty water 

tank 

11

 up to the “

0.5 l

” mark and then 

dissolve two Bosch descaling tablets in it.

●

Press the 

start

 button 

8

. The  descaling 

programme will now run for about 

20 minutes.

Descaling

Not enough descaling fluid.  

Refill fluid 



start

Info: 

If there is not enough descaling solu-

tion in the water tank 

11

, the corresponding 

prompt is displayed. Pour in descaling solu

-

tion and press the 

start

 button 

8

 again.

Clean and refill water tank 



start

●

Rinse the water tank 

11

 and refill it with 

fresh water up to the “

max

” mark.

●

Press the 

start

 button 

8

. The descaling 

programme now runs for about 1 minute 

and rinses the appliance.

Descaling

Empt y drip tray

Repl ace drip tray

●

Empty the drip tray 

23

 and reinsert it.

Replace the filter if one is being used. The 

appliance is ready for use again.

Important:

 Wipe down the appliance 

using a soft, damp cloth to immediately 

remove any descaler residue. Such residue 

can cause corrosion. New sponge cloths 

may contain salts. Salts can cause rust 

film on stainless steel and must therefore 

be washed out thoroughly before use. 

 Thoroughly clean the suction pipe 

10d

 of 

the milk frother.

TES803_805_807_1RW.indb   21

08.05.2013   14:53:02