Liebherr CBN 3956 Premium - Инструкция по эксплуатации - Страница 7

According to the EN 378 standard, the room in which your appli-

ance is installed must have a volume of1 m

3

 per 8 g of R 600a

refrigerant. If the room in which the appliance is installed is too

small,  a  flammable  gas-air  mixture  may  form  in  the  event  of  a

leakage  in  the  refrigeration  circuit.  The  quantity  of  refrigerant

used in your appliance is indicated on the type plate on the inside

of the appliance.

WARNING

Fire hazard due to dampness!

If live parts or the mains lead become damp this may cause short

circuits.

u

The appliance is designed for use in enclosed areas. Do not

operate the appliance outdoors or in areas where it is exposed

to splash water or damp conditions.

WARNING

Fire hazard due to refrigerant!

The refrigerant R 600a is environmentally friendly but flammable.

Escaping refrigerant may ignite.

u

Do not damage the pipes of the refrigeration circuit.

WARNING

Fire hazard and danger of damage!

u

Do not place appliances emitting heat e.g. microwaves, toast-

ers etc. on the appliance!

WARNING

Fire hazard and risk of damage due to blocked ventilation grille!

u

Always keep the ventilation grille free. Always ensure that the

appliance is properly ventilated.

u

Detach the connecting cable from the rear of the appliance,

removing the cable holder because otherwise there will be vi-

bratory noise!

After installation:

u

Remove  the  protective  film  from  the  outside  of  the  appli-

ance.*

u

Apply the stainless steel care product evenly in the direction

of the grain.*

w

Subsequent cleaning becomes easier as a result.*

u

Remove the protective film from the decorative trims.

u

Remove all transit supports.

u

Dispose of packaging material. See section on packaging dis-

posal.

ATTENTION

Risk of damage due to condensate!

u

Do not install the appliance directly alongside a further refrig-

erator/freezer.

u

Level  the  appliance  so  its  stands

firm with the aid of a spirit level by

applying  the  accompanying  span-

ner to the adjustable feet (A).

u

Afterwards  support  the  door:  ex-

tend the adjustable foot at the turn

hinge (B) until it rests on the floor,

then turn a further 90 degrees.

If the appliance is installed in a very damp environment, conden-

sate may form on the outside of the appliance.

u

Always see to good ventilation at the installation site.

4.5 Disposing of packaging

WARNING

Danger of suffocation due to packing material and plastic film!

u

Do not allow children to play with packing material.

The packaging is made of recycable materials:

-

corrugated board/board

-

EPS moulded parts

-

polythene bags and sheets

-

polypropylene straps

u

Take the packaging material to an official collecting point.

4.6 Connecting the appliance

ATTENTION

Risk of damage to the electronic control system!

u

Do not use a stand-alone inverter (DC/AC conversion) or en-

ergy-saving plug.

WARNING

Fire and overheating hazard!

u

Do not use an extension cable or multiple socket outlet.

The type of current (alternating current) and voltage at the site of

installation  must  conform  with  the  data  on  the  type  plate  (see

section relating to the description of appliance and equipment).

Connect  the  appliance  only  with  a  properly  installed

socket outlet with earthing contact. The socket outlet

must be fused with 10 A or higher.
It must be easily accessible so that the appliance can

be quickly disconnected from the supply in an emer-

gency.

u

Check electrical connection.

u

Clean the appliance. For details, see the section on cleaning.

u

Plug in the power plug.

4.7 Switching on the appliance

Note

u

To switch on the entire appliance it is necessary only to switch

on the freezer compartment.

Note

u

After  switch-on,  first  the  freezer  compartment  is  cooled  and

after some time the refrigerator compartment.

Put the appliance into operation about 2 hours before first loading

food to be frozen.
Do  not  load  food  to  be  frozen  before  the  temperature  display

reads -18 °C.

4.7.1 Switching on the freezer compartment

u

PressOn/Off button, freezer compartment

 Fig. 3 (6).

w

The  refrigerator  compartment  temperature  display  indicates

the set temperature.

w

The freezer compartment temperature display and the alarm

button  flash  until  the  temperature  is  sufficiently  cold.  If  the

temperature  is  above 0  °C,  dashes  flash.  If  it  is  below,  the

current temperature flashes.

Putting into operation

7