Bosch KGN56HI20R - Инструкция по эксплуатации - Страница 29

en

29

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following 

information.
Customer service will charge you for advice – even if the appliance is still under 

guarantee!

Fault

Possible cause

Remedial action

Temperature differs greatly 

from the set value.

In some cases it is adequate to switch off 

the appliance for 5 minutes.
If the temperature is too high wait a few hours 

and check whether the temperature has 

approached the set value.
If the temperature is too low check 

the temperature again the next day.

It is too cold in the 

refrigerator section or in the 

chill compartment.

Increase the temperature in the refrigerator 

section.
Push temperature controller for the chill 

compartment downwards. Fig. 

'

The temperature in 

the freezer compartment is 

too warm.

Appliance opened 

frequently.

Do not open the appliance unnecessarily.

The ventilation openings 

have been covered.

Remove obstacles.

Large quantities of fresh 

food are being frozen.

Do not exceed max. freezing capacity.

Appliance is not cooling, 

temperature display and light 

are lit.

Showroom mode is switched 

on.

Press and hold °C button and 

@

 setting button 

for 5 seconds until an acknowledgement 

signal sounds. Another acknowledgement 

signal sounds when the buttons are released.
After a short time check whether your 

appliance is cooling.

The side panels of the 

appliance are warm.

Pipes run into the side panels 

which heat during the 

cooling process.

That is normal behaviour for the appliance and 

not a fault.
Furniture touching the appliance will not be 

damaged by the heat.