ADA Plodder KW55 А00421 - Инструкция по эксплуатации - Страница 14

Plodder 

K28 / KW30 / KW55

1

energy is cosφ (or power factor). It’s value is listed in the passport of the instrument. If cosφ doesn’t equal to 1, it’s necessary to divide 

it in cos φ to know energy consumption. 

Example:

 if there is a sign on the drill 500 W and  cosφ = 0,6, it means that the instrument will consume 500 : 0,6 = 833 W from the generator.  

After detection of consumers it’s necessary to add power of all instruments that are going to be connected.
POWER  OF YOUR  POWERHOUSE  MUST  BE  NOT  LESS  THAN  TOTAL  POWER  +  HAVE  NECESSARY  RESERVOIR(  USU-
ALLY IT IS 10%).

P of  the powerhouse =  Р1 × K1 + Р2 × K2+ … +Рn × Kn

Index K considers initial power for every equipment:
k = 1-1,6 – for consumers with active load;
k =  no less than 3 – for consumers with reactive load; 
k = no less than  5 - 7 – for heavy loaded electric motors(pumps, air compressors).

Switching off the Power Generator

WARNING: Hot components can ignite flammable and explosive materials. Avoid flammable and explosive materials at the operating 
area. Allow appliance to cool.
1. Switch off or disconnect load.
2. Allow motor to continue running for approx. a further two minutes.
3. Push the Rocker switch of motor to the OFF position.
4. Push fuel valve switch to the OFF position.
5. Allow appliance to cool.

Preparation and maintenance in wintertime

Maintenance in winter time is considered to be the period when the temperature of the ambient air is fixed below +5°C. The low tem-
perature of the ambient air hampers the engine start, negatively influences the operation of all its systems. To prepare the generator and