Ryobi RLM46175Y 5133003671 - Инструкция по эксплуатации - Страница 12

English

10

 WARNING

Do not lubricate any of the wheel components. 

Lubrication may cause the wheel components to fail 

during  use,  which  could  result  in  product  damage  and/

or serious personal injury to the operator.

4.  Reinstall the wheel gear with the arrows facing the front 

of the product. Reinstall pins, washer, e-rings, and dust 

cover.

NOTE:

 Ensure the left gear and right gear are in their 

correct location.

5.  Reinstall the wheel and the nut. Tighten the nut to 

secure.

6.  Reinstall the hub cap.

REPLACING THE WHEELS

See figure 17.

 WARNING

Only use replacement wheels approved by the 

manufacturer of the product. Using wheels that are 

not approved by the manufacturer of the product is 

hazardous and could result  in serious personal injury.

1.  Stop the engine and disconnect the spark plug wire. 

Allow blade to come to a complete stop.

2.  Remove the hub cap.

3.  Remove the nut from the wheel axle, then remove the 

wheel. 

4.  Replace with a new wheel and reinstall the nut to 

secure.

STORING THE PRODUCT

When storing the product for 30 days or more:

■

If using a fuel stabilizer, follow the stabilizer 

manufacturer’s directions to add stabilizer to petrol in the 

fuel tank. Run the engine at least 10 minutes after adding 

stabilizer to allow the stabilizer to reach the carburetor.

 WARNING

Do not store the product with petrol in the tank inside a 

building where fumes may reach an open flame or spark.

■

If not using a fuel stabilizer, allow the engine to run until 

the product is completely out of petrol.

■

Once the engine has stopped, allow the blade to come 

to a complete stop and disconnect the spark plug wire.

■

Turn the fuel valve to the closed position.

■

Turn the product on its side (with carburetor facing up) 

and clean grass clippings that have accumulated on the 

underside of the mower deck.

■

Clean the underside of the mower deck.

■

Wipe the product clean with a dry cloth.

■

Check all nuts, bolts, knobs, screws, fasteners, etc., for 

tightness.

■

Inspect moving parts for damage, breakage, and wear. 

Have repairs made on any damaged or missing parts.

■

Store the product in a well-ventilated area that is clean, 

dry, and out of the reach of children. 

■

Do not store near corrosive materials, such as fertilizer 

or rock salt.

To lower the handle before storing:

See figure 18.

■

Remove starter rope from the guide and allow it to 

retract into the engine.

■

Remove the grass catcher.

■

Release the upper quick-release fasteners of the upper 

handle and fold the upper handle down.

■

Release the lower quick-release fastener.

■

Fold the lower handle forward past the edges of the 

handle mounting brackets and make sure that the 

bracket supports the handle; otherwise, the air filter 

may be damaged.

■

Close the lower quick-release fasteners and let the 

bracket support the handle, making sure not to bend or 

kink the control cables.

TRANSPORTATION

■

Stop the product, disconnect the spark plug wire, and 

wait until the blade comes to a complete stop. Allow the 

product to cool down.

■

Empty the fuel tank by running the engine until it stops. 

Empty oil by following the instruction for changing oil.

■

Secure the product against movement or falling to 

prevent injury to persons or damage to the product.