Ecosoft P’URE Balance - Инструкция по эксплуатации - Страница 7

6

7

This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2021

ENG

REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE

2. 

SPECIFICATIONS AND COMPONENTS

2.2. SPECIFICATIONS AND REQUIREMENTS

2.3. WATER QUALITY

2.3.1. SUPPLY WATER QUALITY REQUIREMENTS

*

*        If supply water pressure is below required value, purchase pumped model or fit your existing filter with booster pump. If the 

pressure in the water system is above the limit, it is necessary to install a pressure regulator on the main pipe.

**    If pressure in tank bladder is outside this range, it is necessary to pump up or release the pressure until it conforms to the 

requirement.

*** If supply water temperature is up in the range of +20…+30 °C (+68...+86 °F), rejection of impurities will be decreased and 

system capacity increased, bringing about an increase in TDS. Using the product with supply water temperature in excess of

+30 °C (+86 °F)  is not recommended.

*       If water supply does not meet the requirements, service life of membrane and/or pre-filter cartridges may be shortened.

**     If your home is supplied with raw wellwater, perform laboratory test of your water before installing a reverse osmo-

sis filter. If any of your water indices exceed the limit, consider using a water treatment system to correct supply water 

quality. Refer to water treatment specialists or companies for advice and proper equipment selection.

Do  not  use  with  water  that  is  microbiologically  unsafe  or  of  unknown  quality  without  adequate 

disinfection before or after the system.

Parameter

Value

1 Main pressure (no booster pump), barg (psi)

3-6* (43-87)

2 Main pressure (booster pump installed), barg (psi)

2-4.5 (29-65)

3 Tank bladder pressure, barg (psi)

0.4-0.6** (5.8-8.7)

4 Feed water temperature, °C (°F)

+4…+30*** (39...86)

5 Weight of the system (base model), kg (pounds)

6 (13.2)

6

Ambient temperature, °C 

                                         °F

+5…+40***

+41...+104

7 Water supply connection

½″ thread

8 Filter dimensions, H×W×D (basic assembly), mm 

                                                                               inch

350x450x150

13.8x17.7x5.9

9

Tank dimensions, H×W×D, mm 

                                                inch

350x260x260

13.8x10.2x10.2

Index

VALUE**

1 pH

6.5-8.5

2 TDS

<1500 ppm

3 Hardness

<500 ppm CaCO

3

 (<28 °dH)

4 Free chlorine

<0.5 ppm

5 Iron

<0.3 ppm

6

Manganese

<0.1 ppm

7 Chemical oxygen demand

<5 ppm O

2

8 Total bacterial count (TBC) 

<50 CFU/mL

9

E. coli titer

<3