Ecosoft P’URE Balance - Инструкция по эксплуатации - Страница 25

24

25

This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2021

ENG

REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE

1) Check that all parts are in the package. Do not open the plastic bags with filter parts before you 

make sure everything is in place to be able to return faulty/incomplete package.

2) Check conformity of your local variables to requirements specifications:

— verify that your product is as specified in paragraph 2.2;

— verify that your supply water quality** meets the requirements in paragraph 2.3.

**If supply water quality does not meet the requirements, it is necessary to consult with a water treatment specialist. 

3) Before installing the system, make sure there is enough space for both the filter rack and the pres-

sure tank under the sink. In case there is not enough available space, pressure tank can be placed 

in a separate location provided that the yellow tube’s length is sufficient to connect it to the rest of 

the system. 

4) 

Electrical safety notice:

 This appliance should be connected into a circuit with an RCB installed. 

Please note voltage requirements.

5) Install the system per the guidelines of this manual. 

6) The unit is to be supplied with single-phase 230 VAC, 50 Hz electrical power.

The unit is supplied with power cord and can be connected to a properly installed IEC 60884-1 com-

pliant socket. Electrical specification of the unit can be found on manufacturer’s factory sticker. That 

system and installation must comply with state and local laws and regulations.

4.2. INSTALLATION PROCEDURE 

CAUTION! 

This system has been tested by the manufacturer for leaks, so within the system the 

presence of residual water is allowed. 

Wash  your  hands  thoroughly  with  anti-bacterial  soap  before  handling  tubes,  cartridges,  and 

membrane.

This system should desirably be installed in places protected from direct sunlight and away from 

heating appliances.

4. STEPS FOR INSTALLING REVERSE OSMOSIS SYSTEM

Before installing a domestic reverse osmosis filter please carefully read this instruction.

This system must be installed in compliance with local codes.

4.1. BEFORE COMMENCING INSTALLATION

Main pressure*

Tank pressure* 

Supply water temperature*

Check water pressure at mains 

before installing the product. Com-

pare to the requirements 

in paragraph 2.2.

Check pressure in the tank bladder. 

Compare to the requirements 

in paragraph 2.2. 

Check temperature of supply water. 

Compare to the requirements in 

paragraph 2.2. 

*Refer to paragraph 2.2 for recommended measures in case any of the above variables does not meet the requirements. 

1.

Remove the reverse osmosis system from its packaging and check the equipment. Do not open the bag with compo-

nents. Note that you will not be able to claim missing parts if the bag is opened.

2.

Shut off water supply in your kitchen or whole home and open water tap where you are about to install the system 

(on your kitchen sink) for 1 minute to relieve pressure in the system, and then close it.