GreenWorks GD40TCS - Инструкция по эксплуатации - Страница 6

English (original instructions)

EN

DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET

5

cut and drop the tree along the desired line 

of fall. When the tree begins to fall, remove 

the top handle saw from the cut, stop the 

motor, put the top handle saw down, and 

then use the retreat path as planned. Be 

alert of overhead limbs falling and watch 

your footing. 

LIMBING A TREE 

See figure 11

Limbing is removing the branches from a 

fallen tree. When limbing, leave the larg-

er lower limbs to support the log off the 

ground. Remove the small limbs in one 

cut. Branches under tension should be cut 

from the bottom up, to avoid binding the top 

handle saw.

BUCKING A LOG

See figure 12 - 15

Bucking is cutting a log into lengths. It is 

important to make sure your footing is firm 

and your weight is evenly distributed on 

both feet. When possible, the log should be

raised and supported by the use of limbs, 

logs or chocks. 

Follow the simple direction for easy cutting:

„

When the log is supported along the 

entire   length, it is cut from the top 

(over buck).

„

When the log is supported on one 

end, cut 1/3 of the diameter from the 

underside (under buck). Then make 

the  finished  cut  by  over  bucking  to 

meet the first cut.

„

When the log is supported on both 

ends, cut 1/3 of that diameter from 

the top (over buck). Then make the 

finished  cut  by  under  bucking  the 

lower 2/3 to meet the first cut.

„

When bucking on a slope, always 

stand     on the uphill side of the log. 

When cutting through, to maintain 

complete control, release the cutting 

pressure near the end of the cut 

without relaxing your grip on the top 

handle saw handles.

Do not let the chain contact the ground. 

After completing the cut, wait for the saw 

chain to stop before you move the top han-

dle saw. Always stop the motor before mov-

ing from tree to tree.

MAINTENANCE

WARNING

Always remove the battery pack from the 

machine before checking the chain ten-

sion or making adjustments to the chain. 

Wear protective gloves while touching 

the chain, bar or areas around the chain.

ADJUSTING THE CHAIN TENSION

See figure 2 and figure 7

„

Loosen the chain cover lock nuts with 

the supplied wrench. The chain cover 

lock nuts do not have to be completely 

removed in order to adjust the chain 

tension.

„

Rotate the chain adjustment screw 

clockwise to increase the chain 

tension and rotate counterclockwise to 

decrease the chain tension.

„

Once the chain is at the desired 

tension, tighten the chain cover lock 

nuts.

REPLACING THE BAR AND CHAIN

See Figure 3-7

„

Remove the battery from the top 

handle saw.

„

Remove the chain cover lock nut 

from chain cover by rotating them 

counterclockwise with the wrench.

„

Remove the chain cover from the 

mounting surface.

„

The bar and chain can now be removed 

by lifting it away from the main body of 

the saw and releasing the chain from 

the sprocket.

„

Remove the old chain from the bar.

„

Lay out the new saw chain in a loop 

and straighten any kinks. The cutters 

should face in the direction of chain 

rotation. If they face backwards, turn 

the loop over.