GreenWorks GD40TCS - Инструкция по эксплуатации - Страница 10

English (original instructions)

EN

DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET

9

TROUBLESHOOTING        

PROBLEM

POSSIBLE CAUSE

SOLUTION

Bar and saw 

chain running 

hot and 

smoking.

Check saw chain tension for

overtightened condition.

Tension saw chain.

No oil in the oil tank. 

Refill oil into the oil tank.

The discharge port is 

blocked by debris.

Refer to the manual to remove the bar 

and clean out the debris.

Oil tank is blocked by debris.

Clean out the oil tank and refill with 

clean oil.

Bar and chain oil tank cap is 

blocked by debris.

Clean the debris off the oil cover.

The sprocket or guide 

wheels is clogged with 

debris.

Clean and remove debris from sprocket 

and guide wheel. 

Motor runs, 

but chain is not 

rotating.

Saw chain tension is too 

tight.

Refer to Saw Chain Tension Guide 

earlier in this manual.

Check guide bar and saw 

chain assembly.

Refer to Page 5.

Check guide bar and saw 

chain for damage.

Remove the battery from the unit. Take 

the bar cover off, and remove the bar 

and saw chain. Clean all debris from 

the top handle saw. After all debris is 

cleared, insert battery and run the top 

handle saw. If the sprocket is spinning 

your motor is okay. If the sprocket is not 

spinning, call customer service.

Motor runs, 

chain rotates 

but does not 

cut.

Dull chain.

Sharpen or replace the saw chain.

Chain on backwards.

Refer to Replacing the Bar and Saw 

Chain assembly earlier in this manual.

Chain tension could be 

overtightened or too loose. 

Refer to Re-tensioning the saw chain in 

the manual.