Bosch AVR 1100 - Инструкция по эксплуатации - Страница 24

24

 | English 

F 016 L70 481 | (10.10.08)

Bosch Power Tools

*In conditions with excessive tree debris (e. g. leaves, twigs, etc.) first clear the surface by using the 
machine with a height of cut setting of either 3 or 4.

Maintenance and Service

Maintenance and Cleaning

f

Stop, remove plug from the power supply 
and remove the grassbox.

f

Always wear gardening gloves when han-
dling or working near the sharp tines/blade.

Note: 

To ensure long and reliable service, carry 

out the following maintenance regularly.
Regularly check for obvious defects such as 
loose, dislodged or damaged tines/blades, 
loose fixings, and worn or damaged compo-
nents.
Check that covers and guards are undamaged 
and correctly fitted. Carry out necessary mainte-
nance or repairs before using.

If the machine should happen to fail despite the 
care taken in manufacture and testing, repair 
should be carried out by an authorised custom-
er service agent for Bosch garden products.
In all correspondence and spare parts orders, 
please always include the 10-digit article 
number given on the type plate of the machine.

Removing/Fitting Raker Tines

f

Stop, remove plug from the power supply 
and remove the grassbox.

f

Always wear gardening gloves when han-
dling or working near the sharp tines/blade.

Turn the machine over.
Use long-nose pliers to grip the tine 

12

, press 

down and remove the tine 

12

 from the pin 

11

. 

(see figure G)
The new tine 

12

 is mounted in reverse order.

Machine labours or belt squeals Height of cut too low

Increase height of cut (see “Ad-
justing the Cutting Height”)

Cutting tines/blades not rotat-
ing

Cutting tines/blades obstructed 
by grass

Clear obstruction (always wear 
gardening gloves)

Belt is slipping or is damaged

Contact Service Agent

Excessive vibrations/noise

Cutting tines/blades damaged

ALR 900:
Fit replacment (see “Remov-
ing/Fitting Raker Tines”)
AVR 1100: 
Contact Service Agent

Poor collection

Raking/Verticutting in wet con-
ditions

Increase height of cut (see “Rak-
ing/Verticutting Tips”)

Raking/Verticutting too low for 
the conditions

Increase height of cut

Possible clogging

Check underneath the machine 
and clear out as necessary (al-
ways wear gardening gloves)

Blocked  side  grilles

Clear debris from the outside of 
the side grilles

Missing tine springs (ALR 900 
only)

Replace tine springs (always 
wear gardening gloves)

Problem

Possible Cause

Corrective Action

G

OBJ_BUCH-835-002.book  Page 24  Friday, October 10, 2008  8:40 AM