Bosch AVR 1100 - Инструкция по эксплуатации - Страница 22

22

 | English 

F 016 L70 481 | (10.10.08)

Bosch Power Tools

Note: 

To aid starting push handle down to lift 

front wheels.

Starting 

Press and hold the safety button 

3

.

Squeeze the switch lever 

2

 towards 

the handle.
Release the safety button 

3

.

Stopping

Release the switch lever 

2

.

Working Advice

Raking/Verticutting

Place the ALR 900 /

AVR 1100 on the edge 

of the lawn, as close to 
the power point as 
possible. Work away 
from the power point.
Position the cable to 
opposite side (already 
raked/verticut lawn) at 
the end of each turn.

When raking/verticutting 

do not allow the mo-

tor to labour.
ALR 900:

When the motor labours the speed of the motor 
drops and you will hear a change in the motor 
sound. When this occurs, stop raking, release 
switch lever 

2

 and 

raise the height of cut

. Fail-

ure to do so could damage the machine.

AVR 1100:

The motor is protected by a safety cut out which 
is activated when the blades become jammed, 
clogged or if the motor is overloaded. When this 
occurs, stop using the machine.

The safety cut out will only reset if the switch le-
ver 

2

 is released.

Remove the plug from the power supply, clear 
any obstruction and wait a minute for the safety 
cut out to reset before continuing to use the ma-
chine.

f

Always wear gardening gloves when han-
dling or working near the sharp tines/blade.

Note: 

When waiting for a reset, operating switch 

lever 

2

 too early with the machine plugged into 

the supply will prolong the reset time of the 
safety cut out.
If the machine cuts out again, increase the 
height of cut or postpone use until conditions 
improve. Please refer to “trouble shooting ta-
ble” and “raking/verticutting tips”.

Raking/Verticutting Tips

Optimum conditions for raking/verticutting are 
when the grass is short and slightly damp. Rak-
ing/Verticutting when the ground is very soft or 
hard it will may damage the lawn and will result 
in poor collection.
– Kill moss with a proprietary moss killer be-

fore raking/verticutting.

– Start the ALR 900/AVR 1100 at the highest 

raking/verticutting position and lower as 
necessary.

– Rake/Verticut the lawn in the one direction, 

then proceed at right angles a week later un-
til the whole lawn has been completed.

– The action of removing moss and debris dur-

ing raking/verticutting may reveal ragged and 
bare patches depending on lawn conditions.

Note: 

In conditions with excessive tree debris 

(e. g. leaves, twigs, etc.) first clear the surface 
by using the machine with a height of cut setting 
of either 3 or 4.
For best results mow the lawn before reseeding. 
Promote the spread of grass into bare and weak 
areas with good quality lawn seed after rak-
ing/verticutting. Allow fresh grass seed to root 
and establish before fertilising, where neces-
sary water to prevent fresh seeds drying out.
Ideal times for raking/verticutting are spring and 
late autumn.
Also lawn can be maintained by raking/verticut-
ting on a higher setting after every six cuts.

E

F

0

I

2

1

60 sec

Auto-Stop

Start

OBJ_BUCH-835-002.book  Page 22  Friday, October 10, 2008  8:40 AM