Kuppersberg 60 X - Инструкция по эксплуатации - Страница 27

27

ENGLISH

TECHNICAL PASSPORT

Cooker hood

8.C L E A N I N G  A N D  M A I N T E N A N C E

8.8 Replace 

(optional) carbon 

filters  used  during  recirculation  mode 

every 3 – 6 months depending on the 

intensity of using of the cooker hood. 

To  install  the  filters  on  a  T-shaped  pin 

of a turbofan lid, axial pressure and 

clockwise rotation are required.

8.9  The cooker hood is equipped 

with an LED lamps to illuminate a 

cooktop. Before replacing the light 

bulbs, switch the cooker hood off and 

allow them to cool down.

Remove the lamp from the hood 

housing by pulling it out and disconnect 

the wire from the battery (Fig. 7).

Then, install a new one with the 

same characteristics and insert the 

filters.

8.1 

CA U T I O N!  Before cleaning, 

switch the cooker hood off.

8.2 For external cleaning of 

stainless steel cooker hood, use 

special agents and follow the relevant 

instructions.

8.3 Do not clean the cooker 

hood with abrasive detergents, coarse 

sponges or cleaning agents containing 

soda ash, acids, chlorides or solvents.

8.4  When washing, avoid moisture 

entering the conductive parts of 

the cooker hood, and especially the 

electronic control unit. After washing, 

wipe all surfaces with a soft cloth.

8.5  You can use conventional glass 

cleaning agents to clean glass surfaces.

8.6  Since  an  aluminium  filter 

becomes clogged with airborne grease 

and dust, presoak it in hot water with 

an effective detergent and wash 

every 

1.5 - 2 months.

Changing  the  colour  of  the  filter 

after washing does not affect the 

performance quality.

8.7  To remove the aluminium filter 

(Fig. 6), press on the spring sliding part 

and,  pulling  down,  remove  the  filter 

from  the  panel.  Install  the  filter  in  the 

reverse order/

Do  not  install  filter  after  washing 

until it is completely dry.