Falmec Mimosa GOFRA 90 - Инструкция по эксплуатации - Страница 20

18

Square halogen light

3.   FLUORESCENT TUBE

(Section reserved for qualified installers)

Replacing the fluorescent tube:
a)  Disconnect the device from the mains;
b)  Unscrew the fixing screws and remove the bottom panel;
c)  Remove the fluorescent tube, by rotating through 90°, and replace it with one of similar 

features (8W-13W-21W-28W according with the model);

d)  Reconnect the device to the mains.

MAINTENANCE AND CLEANING

L

Constant maintenance ensures the correct operation and efficiency of the appliance over 
time. Special attention should be paid to the metal grease-trapping filters and the charcoal 
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do 
not accumulate on the range hood, with the consequent risk of fire.

1.  METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore should be 
washed every month in hot water and detergent, without bending them. Wait until they 
are completely dry before repositioning them.  To remove and replace these filters, see 
the instructions in point H1. This operation should be performed at regular intervals.

2.   CHARCOAL FILTERS

These trap the odours present in the stream of air that passes through them. The air is 
purified by passing a number of times through the filters and being recirculated into the 
kitchen. The charcoal filters cannot be cleaned, and should be replaced on average every 
3-4 months (according to use). To replace the charcoal filters, see the instructions in point 
H2.

3. CLEANING THE OUTSIDE OF THE APPLIANCE

It is advised to clean the external hood surfaces at least every 15 days in order to avoid 
that oily or greasy substances affect the steel surfaces. 

The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid 
detergent or denatured alcohol. 

In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using 
clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain 
abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using 
abrasive substances or rough cloths will inevitably damage the finish of steel. 

The steel surface will be irrevocably damaged if the instructions above are not complied 
with.

Keep these instructions together with the instructions for use of your hood. 

The manufacturer accepts no liability for any damage caused by non-compliance with the 
instructions above.