Falmec Lumina 120 - Инструкция по эксплуатации - Страница 29

27

seconds.  During flashing, at least one radio control key must be pressed.  The function will 
deactivate upon completion of the 10 seconds, or earlier if a compatible remote control is 
detected.

Key pressure management:
 

Prolonged pressure =

 finger pressed on key for at least 3 seconds, the function activates 

during pressure.

Non-prolonged pressure =

 finger pressed on key for less than 3 seconds, the function 

activates upon its release.

Radio control (optional):

 Place the device far from sources of electromagnetic waves 

which could interfere with the range hood’s electronic functions

Maximum operating distance 4 metres.  This distance may vary in defect based on elec-
tromagnetic interference of other devices. 

Function of the 

remote control

DESCRIPTION

Light Key

Pressing the Light key will switch the light on/off

‘ - ‘ Key

Pressing the ‘-’ Key will decrease motor speed. If 1° (1st) speed is in gear, pressing 
the ‘-’ key will turn off the motor

‘ + ‘ Key

If the motor is turned off, pressing the ‘+’ key will activate the motor at 1° (1st) 
speed. If the motor is operating, pressing the ‘+’ key will increase motor speed up 
to the maximum.

Timer Key

If the motor is active, pressing the timer key will activate/deactivate the timer 
function

Code Change 
(only in case of 
malfunction)

Press the “Luce” (Light) key together with the “Timer” key of the remote control 
until the blue LED begins to slowly flash. If the “-” key of the remote control 
is pressed within 5 seconds, the new code will be generated and memorised. 
Memorisation is confirmed by 3 brief flashes of the LED.
To return to the default code, apply pressure on the “-” key together with the “+” 
key for over 5 seconds. Memorisation of the default code will be signalled with 3 
brief flashes of the LED.
Each time that a new code is generated or that the default code is set in the 
remote control, it is necessary to also carry out the previously described Remote 
Binding (Light Key of the pushbutton) procedure. 

FILTERS

REMOVING AND REPLACING’S INSTRUCTIONS

H

1. METAL FILTERS

To remove the anti-grease metal filters, just act on the specific handle. In the perimeter 
suction hoods (horizon nrs, lumina nrs, vela nrs) remove the steel panel as indicated in fig. 
H3 and then remove the metal filters.

2. CHARCOAL FILTERS

To assemble or replace the charcoal filters, see the instructions in the specific optional 
charcoal filter kit for each model.

Plane nrs hood:

 filter code kacl.921

Horizon nrs 1 motor, lumina nrs hood:

 filter code 101078900 (2 per hood)

Horizon nrs 2 motor hood: 

filter code 101078900 (4 per hood)

Vela nrs hood:

 filter code 101078900 (1 per hood)

To order new charcoal filters, contact your distributor/dealer.

ONLY FOR ITALY:

 Download the filter order module from the website:

www.falmec.com (access the drop-down assistance menu).

English