Elica OM TOUCH SCREEN WH/F/80 - Инструкция по эксплуатации - Страница 11

11 

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 

same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  

Therefore, we recommend observing these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Steam screen 

The steam screen must always be left closed and 
opened only for maintenance (e.g. cleaning or changing 

filters).   

Grease filter 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 

When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
Open the steam screen.  
Pull the handle downwards and extract the filter. 

Fig. 2 

Charcoal filter (filter version only) 

Fig. 3 
It absorbs unpleasant odours caused by cooking. 

The charcoal filter can be washed once every two months (or 
when the filter saturation indication system – if envisaged on 
the model in possession – indicates this necessity)   using hot 
water and a suitable detergent, or in a dishwasher at 65°C (if 
the dishwasher is used, select the full cycle function and leave 

dishes out). 
Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 
  

Fig. 3 

• 

Montage 

Open the steam screen and remove the grease filter.  

Install the carbon filter on the back of the grease filter and 
fix with two rods.    

Attention!

 The rods are included in the carbon filter 

packing and not on the hood.   

• 

To dismantle the filter act in the reverse manner. 

Replacing lamps 

Fig. 4 

Disconnect the hood from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 
  

Fig. 4 

• 

Use a small screwdriver as a lever on the borders of the 
lamp in order to remove the lightbulb. 

• 

Slide out the lightbulb to be replaced and replace with a 
new 12V 20W MAX 30° Ø35 12V GU4. 

• 

Carry out the replacement and mount the new lightbulb 
by following instructions in the reverse. 

If the lights do not work, make sure that the lamps are fitted 
properly into their housings before you call for technical 
assistance.